Ask Experts Questions for FREE Help !
Ask
    teckler's Avatar
    teckler Posts: 1, Reputation: 1
    New Member
    		  
    #1

    Nov 16, 2009, 06:08 AM
    Weathermaker 8000 blower trouble.
    I just installed a Weathermaker 8000 in my camp after converting it from natural to propane. It seems to start up fine, but the blower runs continuously-weather burners are ignited or not. Any insight to this would be greatly appreciated. Tim
    hvac1000's Avatar
    hvac1000 Posts: 14,540, Reputation: 435
    Heating & Air Conditioning Expert
    		  
    #2

    Nov 16, 2009, 10:47 AM
    Disconnect G/Green wire from the circuit board. If the fan shuts off then it is a wiring or thermostat problem. If it does not shut off then it could be a defective fan relay.
Not your question? Ask your question View similar questions
 

Question Tools Search this Question
Search this Question:

Advanced Search

Add your answer here.


Check out some similar questions!

Carrier Weathermaker 8000 trouble codes? [ 11 Answers ]

Can anyone tell me where I can find a list of troubld codes for my Carrier Weathermaker 8000? Thanks. Charley

Carrier weathermaker 8000 [ 7 Answers ]

Says aux heat is on but blower doesn't come on.Why?

Weathermaker 8000 blower not working [ 5 Answers ]

I have a Carrier Weathermaker 8000 two speed system. I went away for 4 days this week and left central air on as usual but, I also left my blower running to circulate air while I was gone. When I returned home my central air unit was froze up, which happens occasionally but also my blower was not...

Carrier weathermaker 8000 [ 3 Answers ]

I have a carrier weathermaker 8000 gas furance... when the thermastat calles for heat the furance turns on it willgo for 3 for 4 min... then the flame stops and the blower runs for the 128 seconds... this is all normal... but the thermastat is still calling for heat and the furance kick on again...

Carrier Weathermaker 8000 Trouble Code [ 2 Answers ]

I have a carrier Weathermaker 8000. Started up furnace and forgot to remove baffle. Now have trouble code 33 and have to manually reset. How do I accomplish this?

View more questions Search