Not your question?
Ask your question
View similar questions
Add your answer here.Check out some similar questions!
Shower arm broke with stem still attached to pipe
[ 4 Answers ]
Hi, my shower arm broke off and the stem is still attached to the pipe. I can't get it off as the hole in the tile is too much, is there a solution to this without breaking the tile?
Leaky Pipe Thread
[ 10 Answers ]
I am threading a male 3/4 in. copper connector into a female cast metal valve body. The first time I used 3 wraps of teflon tap and it leaked. The second time I used Master Pumber TFE past and it leaked after 10 minutes. I allowed the paste to dry for 1/2 hour before turning on the water supply....
Small pipe attached to shower head broke off
[ 31 Answers ]
We were changing the shower head and the 3-4 inch pipe attached to the shower head broke off and parts of it corroded into the 3 -4 inch pipe in the wall that . I don't want to damage the threads to get the very thin lining of the other pipe in so we can screw a new shower head in. It had not been...
Shower pipe broke off in drop eared ell
[ 4 Answers ]
Any suggestions on how the get the threads out of the ell? I was investigating a leaky shower head and it ended up being the pipe and ell. The pipe had a break near the ell and while trying to remove it, it broke off. Thanks
How much pipe thread tape to use?
[ 5 Answers ]
Yikes. I was installing the tub spout and the copper stub-out was way too long. I measure and measured again and cut it too short. It doesn't extend far enough Into the spout to seal. Can I use silicone or something? What others options To I have? The spout is the type you described in a... View more questions Search
|