Ask Experts Questions for FREE Help !
Ask
    rws41's Avatar
    rws41 Posts: 1, Reputation: 1
    New Member
     
    #1

    Nov 8, 2009, 05:54 PM
    Cutting a larger hole in a Corian countertop
    I am replacing the fuacet in my kitchen and need to enlarge two holes in the countertop. Please advise what type of cutting tool is best to use and any helpful hints.


    Thanks,


    RWS41
    ballengerb1's Avatar
    ballengerb1 Posts: 27,378, Reputation: 2280
    Home Repair & Remodeling Expert
     
    #2

    Nov 8, 2009, 07:27 PM

    You should use a https://www.askmehelpdesk.com/plumbi...13171-new.html

    Which will require you to fill the old hole first. I usually plug the old hole with a proper sized dowel and then soak with water for a few minutes. This will allow you to re-establish a place for the pilot drill to get cenetred. Treat Corian like hard wood, tools are pretty much the same.

Not your question? Ask your question View similar questions

 

Question Tools Search this Question
Search this Question:

Advanced Search

Add your answer here.


Check out some similar questions!

Cutting, seaming corian countertop [ 1 Answers ]

I have a free corian countertop, which is exactly the correct length for my kitchen countertop over my cabinets. However, the integrated sink is in the wrong place. I want to cut off one end and then take that piece and add it to the other end. I have the corian adhesive, which I bought over the...

Cutting corian for an open hole [ 5 Answers ]

I'm trying to cut a hole about 7" diameter in a corian counter top to use for trash. How do I get a finished (smooth) edge like the edge of the countertop itself?

Cutting notches a Corian countertop [ 11 Answers ]

I have a Corian counter top. I purchased a stainless steel slide-in range. Because the range is wider in the front, it will not slide all the way into the counter top opening. I need to cut notches in the counter top on either side of the opening about 1/2 inch wide by 2 inches deep. Can I do this...

Cutting a corian countertop [ 4 Answers ]

I need to enlarge the opening for a new cooktop in my corian counter by 1/2 inch. I've been told that I can do this with my jigsaw and a wood cutting reverse blade after taping the area to be cut. Is this correct? If not, how would I do this? I would prefer to use my jigsaw rather then a router...

Cutting through corian countertop [ 1 Answers ]

What is the best way to cut through a corian countertop. We bought a new slide in range - but this one is a couple of inches wider than our old one. The countertop has to be cut to fit in the new range. Can anyone offer suggestions?


View more questions Search