Ask Experts Questions for FREE Help !
Ask
    mentommy's Avatar
    mentommy Posts: 1, Reputation: 1
    New Member
    		  
    #1

    Nov 5, 2009, 11:07 AM
    Car will not start
    I have a 2005 G35 coupe with about 90000 miles .

    Notices recently that my starter was going out or so I thought . Took it to the mechanic and he confirmed that was the case . He changed the starter and on my way home I went to get gas and when I went to start the car and it wouldn't turn over . I called him he met me at the Gas station and took a lok at it and said it was the alternator now. He said that is how it ussually happens , when one goes out the other is close to follow . So , he replaced the alternator . I go to start the car this morning and nothing the car won't turn over again. Help what else could it be ? Obviously this mechanic doesn't know .
    TxGreaseMonkey's Avatar
    TxGreaseMonkey Posts: 16,761, Reputation: 5597
    Uber Member
    		  
    #2

    Nov 5, 2009, 01:24 PM

    Remove and fully charge/replace the battery. Most auto parts stores will test and charge batteries for free.

    If I'm right, and it's the battery, insist the mechanic refund some money. Otherwise, that's repair work at its worst.
Not your question? Ask your question View similar questions
 

Question Tools Search this Question
Search this Question:

Advanced Search

Add your answer here.


Check out some similar questions!

Hard start, white smoke at start, shakes a little [ 4 Answers ]

Hello, I have a 94 Toyota Previa, It usually runs really well but lately it has been having some hard starts and spills out white smoke only at start-up, but the smoke goes away after driving for a little bit. It also will shake a little at stops, it hasn't had any problem with dying though. After...

Kenmore dryer won't start could be start button or timer [ 1 Answers ]

Please help me with this. My dryer was working good and now it won't start at all.

No HSI start GMNT Goodman Janitrol No flame start [ 1 Answers ]

I have a Janitrol (Goodman) furnace, and the controller board indicates 3 blinks. The flame blower starts, but it never gets to HSI (the ignitor never starts heating up). I've changed the controller board, and same issues. I've been through every sensor (bypassing all of them), and still no...

Lawn mower won't start , changed Plug , but Still won't Start [ 2 Answers ]

My lawn mower won't Start , I tried Changing the Plug , But still won't Start

Can't start my Poulan chainsaw. Start rope too hard to pull. [ 1 Answers ]

Can't start my chainsaw because the start rope is too hard to pull out. Pulling the rope causes a jerky action.

View more questions Search