Ask Experts Questions for FREE Help !
Ask
    bishsmonogo's Avatar
    bishsmonogo Posts: 1, Reputation: 1
    New Member
    		  
    #1

    Nov 1, 2009, 01:02 PM
    Welder wiring
    I just purchased a Chicago Electric Dual Mig welder. I wired a #10 outlet and have power to the machine, but it does not turn on. Was wondering if they run off two hots and a ground, which I have wired, and have 110 on each side of the plug. Is this correct?
    donf's Avatar
    donf Posts: 5,679, Reputation: 582
    Printers & Electronics Expert
    		  
    #2

    Nov 2, 2009, 08:15 AM

    What is the required voltage and amperage of the welder?

    If the welder requires only 240 VAC, then your wiring is correct providing that you are using a dual 30 Amp breaker. And a #10/2 AWG cable.

    If the welder requires 240/120 VAC, then you need to install a #10/3 cable.


    When you said a "#10" outlet, are you actually saying that you installed a receptacle listed for 30 Amps?
Not your question? Ask your question View similar questions
 

Question Tools Search this Question
Search this Question:

Advanced Search

Add your answer here.


Check out some similar questions!

Wiring my new welder [ 23 Answers ]

Hi, I just got my new mig welder that runs 220V/20A input, current type-single. In my garage I have outlet for 220 which I use for arc welder that has three wire two hot and one for ground. New welder came without plug on it but it also has three wire (white, black and green). I connected new plug...

Wiring a welder [ 3 Answers ]

I have a quick question about hooking up a welder. Lincoln 225/125 AC DC with a 3-prong plug. I am using 8-3wire, can I use the white wire as my ground in the panel and can I also use the bare wire connected to an anchor screw in the plug to the same ground connection in my panel? Thanks, Dale

Wiring my new welder [ 2 Answers ]

Hi, I just got my new mig welder that runs 220V/20A input, current type-single. In my garage I have outlet for 220 which I use for arc welder that has three wire two hot and one for ground. New welder came without plug on it but it also has three wire (white, black and green). I connected new plug...

220 wiring for an arc welder [ 6 Answers ]

I want to hook up a 220v arc welder. I have a 50 amp double pole breaker. The outlet is going to be placed within 6 feet of my breaker box. I believe I have to use 3 wire romex with a bare ground wire. Is this correct? Next, do I connect the black wire to one side of my breaker, the red to the...

View more questions Search