Ask Experts Questions for FREE Help !
Ask
    thclela's Avatar
    thclela Posts: 2, Reputation: 1
    New Member
    		  
    #1

    Nov 1, 2009, 10:29 AM
    New 3 ton amana heat pump fan won't shut off
    I just had a new amana 3ton heat pump installed and the indoor fan unit won't shut down. The tstat is a new ts4275 with 3 options for the fan-on,auto, and prog. Anybody have a salution for this?
    hvac1000's Avatar
    hvac1000 Posts: 14,540, Reputation: 435
    Heating & Air Conditioning Expert
    		  
    #2

    Nov 1, 2009, 10:40 AM
    Post exact brand and model number of thermostat. Ts4275 not listed. Where is the company that installed your new heat pump? They should be responsible for proper operation. Also post outside unit model number and the inside unit brand and model numbers. I can try and pull up a wiring diagram
    thclela's Avatar
    thclela Posts: 2, Reputation: 1
    New Member
    		  
    #3

    Nov 1, 2009, 11:42 AM

    Condenser asz160361ae evap -- aepf313716aa tstat white rogers1f95-1291
    hvac1000's Avatar
    hvac1000 Posts: 14,540, Reputation: 435
    Heating & Air Conditioning Expert
    		  
    #4

    Nov 1, 2009, 01:12 PM
    here is a complete manual for your model thermostat.

    http://www.white-rodgers.com/wrdhom/.../0037-6914.pdf

    Your indoor unit model number meaning

    A Single Piece E Multi-Position Variable-Speed Painted Flowrator (AEPF)

    This means you have a variable speed unit.

    Here is a copy of your complete install manual. NOTE this is a multi unit manual so look for your model number to get the exact specs/info.

    http://www.hvacpartsshop.com/asc%20series.pdf

    Now you have all the info available to trouble shoot your unit.

    NOTE: Variable speed units need special tools to setup properly. You also have to be trained to use those tools properly. Since this is the case I would call back whoever installed the unit for you since damage can happen to the unit by persons who have no idea exactly what they are doing. I say this also so your warranty is not void on the new unit.
Not your question? Ask your question View similar questions
 

Question Tools Search this Question
Search this Question:

Advanced Search

Add your answer here.


Check out some similar questions!

How much freon should be in my amana heat pump, I think it is 2 ton [ 2 Answers ]

How much freon shoud be in my amana heat pump, I think it is 2 ton

Amana heat pump not heating properly [ 2 Answers ]

I have two heat pumps one for upstairs and one for main level.Upstairs blower is in attic and main level one is in basement.I can hear then blower and feel air coming out of registers upstairs.Main level can't feel air coming out and it sounds like the fan is stuck or something because I can hear a...

Amana Heat pump High pressure switch tripping [ 19 Answers ]

Called tech found unit pressure switch tripped, reset added freon. Lasted less than a week. Appears tripped again. He mentioned fan could be the culprit when he was out. Is there a way to eliminate this as a cause? Any other possible solutions? Brand new filter in unit after first episode.

My heat pump won't shut off on its own! [ 4 Answers ]

I have a 2 ton Payne heat pump that is truly living up to its name "Pain". It's performance is very inconsistent. 99% of the time, the heater runs constantly. It won't go into on/off cycles on its on. 1% of the time it will remember how to work correctly, and may cycle on and off a few times. ...

Heat Pump will not shut off [ 53 Answers ]

I have a Bryant heat pump that was used very little over the winter. When I went to turn on the air conditioning a few days ago, the outdoor unit would not come on, but the indoor fan and thermostat appeared to be working fine. I checked the contactor and it was not pulling in, when I pushed it...

View more questions Search