 |
|
| Browse | Ask | Answer | Search | Join/Login |
|
|
||||
|
Heat pump will not run
I had a ruud heat pump and the compressor went bad. I now have a Duroguard 10 seer DPBC-036JA. In the AC mode the contactor chatters and if I bump the unit it kicks on and works normal, however it must be bumped (bang on side of unit) every time. In the heat mode the Thermostat clicks and the nothing happens. I currently have it set in the them heat mode, the furnace fan runs the outside unit does nothing. I have changed the thermostat, the contactor and the transformer. I have had two HVAC people out to look. I am now being told that the air handler and the heat pump are not compatible. Please help!
|
||||
Check out some similar questions!
My Goodman heat pump, model GSH130361AD, heat does not switch on (outer unit). When it first went out, the Honeywell T8411R t-stat digital display went blank. First, I tried replacing the stat with other, but they only accommodated 5 wires. Wiring to the Honeywell was 7 wires. I'll come back to...
I have tried to install Honeywell 7500d thermostat. I get heat pump heat but no emergency heat although the termostate is calling for it. The installation manual says to see authorized agent if I have a dual 0/b on existing thermostat and another wire is attached to common. As of now, I have ...
I have a Janitrol A/C and heat pump system. I replaced the thermostat with a Lux T9000LC The A/C works fine, but the heater does not. I have it wired as follows: G - Green Y - Yellow W - White RH - Pink B -
Hi The A/C works great but in the morning when its cool outside and I switch on the Heat the indoor unit makes a clicking sound and the fan stays off - after about 8 minutes I switch to A/C I get a rush of ice cold air along with some mist. Seems like when I switch to heat the indoor unit...
View more questions Search
| Question Tools | Search this Question |
Add your answer here.
|
