Ask Experts Questions for FREE Help !
Ask
    Craig V's Avatar
    Craig V Posts: 2, Reputation: 1
    New Member
    		  
    #1

    Oct 25, 2009, 09:12 AM
    Bryant #350MAV exhaust motor makes a gravelly noise
    Bryant #350MAV exhaust motor makes a gravelly noise, is the problem the motor or is there a bearing that can be replaced?
    hvac1000's Avatar
    hvac1000 Posts: 14,540, Reputation: 435
    Heating & Air Conditioning Expert
    		  
    #2

    Oct 25, 2009, 01:20 PM
    I believe the bearing is in the motor. You will need to replace the motor or in some cases the entire assembly. Sometimes it is better to replace the entire assembly since getting it apart to remove the blower wheel can be a problem. Then you have to put it back together.
Not your question? Ask your question View similar questions
 

Question Tools Search this Question
Search this Question:

Advanced Search

Add your answer here.


Check out some similar questions!

Bryant plus 90 350mav code 34/14 [ 5 Answers ]

I have a Bryant 350mav that is giving a code 34 followed by a code 14 . I checked the intake and exhuast pipes and they are clear. What next? It is blowing cold air, cycles the 3 times and then locks again.

New Bryant furnace makes a rumbling noise [ 6 Answers ]

I purchased a new Bryant 2 Stage furnace last year and it now makes a rumbling / vibration noise when the furnace kicks into the second stage. It seems like it does this when the furnace gets a lot of use. For instance, Today it turned on once or twice and no rumbling/vibration noise. However,...

Bryant 350MAV only runs in the mornings [ 6 Answers ]

Hi Everyone, I have a strange intermittent problem with my Bryant 350MAV furnace that has arisen in the last couple of months, since the weather started to cool here in Los Angeles. I usually turn off the thermostat at night when I go to bed, then manually turn on the heat in the morning when...

Bryant Model 350MAV Furnace [ 3 Answers ]

Hi, I recently had a furnace repairman in who told me our inducer on our Bryant Model 350MAV furnace needed to be replaced. He said the total cost would be $1075.00, including $890.00 for the inducer. This seemed high to me. Can anyone give me an idea of what this repair should have cost,...

Ceiling fan with light kit on separate switches [ 1 Answers ]

I have recently replaced a ceiling fan with light kit with a newer model. I hooked up the wires from the new fan/light to the same wires in the ceiling box that the old fan was hooked up to. There are two switches on the wall plate, one for the light and one for the fan. When I hooked up the new...

View more questions Search