Ask Experts Questions for FREE Help !
Ask
    LanMan1991's Avatar
    LanMan1991 Posts: 1, Reputation: 1
    New Member
     
    #1

    Oct 22, 2009, 06:38 AM
    Goodman GMV Vent Blower Won't Start
    I have a Goodman Gas GMV095 that's almost two years old. It won't start, the control board has a red light that flashes 3 times. When the thermostat calls for heat the control board makes about 2 clicks. After about 15 seconds the control board starts flashing again. The thermostat goes from heat to AUX Heat. I power cycle the furnace and the same thing happnens again. The venter motor never even starts, it spins freely. Any suggestions? Can I connect 115V Ac to the venter motor to see if it's the issue.

    Help!

Check out some similar questions!

Goodman furnace doesn't come on.blower doesn't start [ 13 Answers ]

Hi, I have a Goodman Furnace GMP075-04 about 9 years old.. it doesn't come on when I switch my thermostat to heat... I replace the ignitor last year and it worked fine until now... blower doesn't come on either... I tried turning the air conditioner on and it works fine... I have went through the...

Goodman blower motor will start when hand spun. Capacitor? [ 4 Answers ]

I posted before about my air handler not kicking on. I crawled up to the attic. I found that if I spin the blower motor once by hand, the unit will run normally until it is turned off. Then, it won't start as before. Is this the capacitor on the side of the blower? It is a Goodman heat pump...

Goodman Furnace blower (fan) does not start [ 4 Answers ]

The furnace and blowers is little over a year old. It was reportedly making some screeching noise then stopped and it almost sounded like it attempts to start then it stops. I don't know where and what to look for start trouble shooting. Any help would be appreciated!

No HSI start GMNT Goodman Janitrol No flame start [ 1 Answers ]

I have a Janitrol (Goodman) furnace, and the controller board indicates 3 blinks. The flame blower starts, but it never gets to HSI (the ignitor never starts heating up). I've changed the controller board, and same issues. I've been through every sensor (bypassing all of them), and still no...

Goodman vent motor [ 12 Answers ]

I have a gmnt 80-4b furnace that stopped running. The vent motor is not getting any power. I have power at both sides of the high limit switch, power to the flame sensor, and power to one side of the pressure switch. Anybody know why I am not getting power to the vent motor?


View more questions Search
 

Question Tools Search this Question
Search this Question:

Advanced Search

Add your answer here.