Ask Experts Questions for FREE Help !
Ask
    akahelleya's Avatar
    akahelleya Posts: 2, Reputation: 1
    New Member
    		  
    #1

    Nov 4, 2006, 03:46 AM
    Pressure Calulations
    I would like to know the formulae for calculations of Pressure before & after the Ventury.:)
    tkrussell's Avatar
    tkrussell Posts: 9,659, Reputation: 725
    Uber Member
    		  
    #2

    Nov 4, 2006, 04:01 AM
    Take a look to see if what you need is here:

    http://hyperphysics.phy-astr.gsu.edu/hbase/hframe.html
Not your question? Ask your question View similar questions
 

Question Tools Search this Question
Search this Question:

Advanced Search

Add your answer here.


Check out some similar questions!

Pressure/bladder tank losing pressure? [ 11 Answers ]

Well, I have asked some questions about my plumbing before. So I am calling on you guys once again. I have a 52 gallon pressure tank/bladder tank made by wellsaver. I turn the water on and have good pressure for a few minutes then it basically goes dead with no pressure. I recently posted questions...

Pressure [ 1 Answers ]

I am 29 weeks pregnant and have been having a lot of pressure in my pelvic area for 3 or 4 days with a dull back pain I went to the dr and he checked for dialation I wasn't but what else could this mean

R-22 Pressure [ 7 Answers ]

It is 99 degrees here the inside temp in my home is 75. This is as cool as it will get. What would be a good range of pressure for my system? I am running 70 on the low side and 250 on the High. Also the home is around 1900 sq. ft. brick R25 in the attic with storm windows. What is an est....

Tank Pressure vs Pump Cut Out Pressure for Well [ 1 Answers ]

I am trying to increase my water system pressure to the minimum required 40 PSI to feed my reverse osmosis drinking water filter. However, the 33 gallon pressure tank for my well pump system says it is pre-charged at 30 PSI and that the cut in pressure for my pump should be set equal to that 30...

Low water pressure in an area known for high pressure [ 3 Answers ]

Greetings, My wife and I are in the process of updating 1957 side by side split level. The previous owner (OK, my Mom as I bought the house I grew up in from her) said that when they moved in they had to install a pressure reducer into the line. I have searched high and low but, I can't see...

View more questions Search