Ask Experts Questions for FREE Help !
Ask
    dhornback's Avatar
    dhornback Posts: 1, Reputation: 1
    New Member
    		  
    #1

    Oct 12, 2009, 11:25 AM
    How do I adjust the temp. at which the heat cycles on and off on a GE Weathertron.
    GE Weathertron thermostate; how do I adjust the temp. at which it cycles on/off?

Check out some similar questions!

Furnace cycles but never reaches set temp [ 1 Answers ]

I have a gas furnace and a daypart thermostat. The heat level never rises above or below 64 degrees, even though the temperature is set for 72 during the day. This started about 1 week ago. I have replaced batteries in the thermostat, replaced filters - and even replaced the whole thermostat. ...

C/A compressor cycles frequently when outside and inside temp are the same, 75 degree [ 3 Answers ]

I have an Amana C/A that runs normally during the day but late in the evening when the outside temp is the same as the inside temp the compressor turns off and then back on again in short cycles. We had a repairman out and he said it was the timer on the unit and that we didn't need it as we had a...

Heat not kicking on until the temp dips below 64 degrees, target temp set to 72 [ 2 Answers ]

Hello, This is my first time posting here, but I figured it was a good place to start for some advice. I just bought a new townhouse a few weeks ago and have been having some heating issues since moving in. The actual furnace (Goodman GMS 8045) was installed in June of '06 while the unit was...

Weathertron heat pump [ 1 Answers ]

I Bought My House Last Oct. The Previous Owners Had A New Unit Put In 07/26/2005. It Has An Entended Warranty On Same For 5 Yrs Compressor 5 Yrs Parts.the Unit Was Cleaned And Serviced Before I Purchased The Hse. I Lived In The Hse All Summer Prior To The Purchase And Had No Problems The Year...

Goodman furnace cycles but does not reach set temp [ 2 Answers ]

I have a Goodman 70,000 BTU, up flow gas furnace (GMV950704CXA) with a Honeywell (RTH 7500D) thermostat installed, November 2006. The unit worked fine until outside temperature went into the 20s. Unit fires and goes through normal sequence and runs for approximately 7 minutes, then cycles down...

View more questions Search
 

Question Tools Search this Question
Search this Question:

Advanced Search

Add your answer here.