Not your question?
Ask your question
View similar questions
Add your answer here.Check out some similar questions!
Switching from old Lennox to new thermostat
[ 2 Answers ]
The old thermostat is a Lennox t-90 mercury thermostat. It has 4 wires with an ac unit and a heating unit. There are no heat pumps on the system. The old t-stat Lennox T-90 has 5 terminals labeled G,F,C,H,and V. It has a jumper wire between the G and F. New thermostat is a Honeywell...
Switching 2 wire to 4 wire for new programmable thermo
[ 6 Answers ]
I am hoping this is a simple question. I am trying to hook up 3 programmable thermostats for my oil furnace that has 3 heat zones - (forced water system). I bought a thermostat for each zone or heat pump. Each heat pump has a two wire set up with a red and a white/yellow wire. When I was at...
Switching my thermostat!
[ 7 Answers ]
I'm trying to switch my old Trane thermostat BAYSENS008B to a hunter44660 having problems matching up the wires.
Replacing Analog Thermostat with Non-Programmable Digital Thermostat
[ 1 Answers ]
Replacing Analog thermostat with White, Yellow, Red, & Black wiring with non-programmable digital thermostat Model #RTH3100C. Please help!!
Switching to programmable, too many wires?
[ 1 Answers ]
I am trying to switch to a programmable thermostat in a house I am remodeling. It is a Trane system. I really don't know much, other than there are 10 wires that go to the thermostat, 9 of which are connected. The current thermostat is a trane "weathertron" and I'm trying to install a honeywell... View more questions Search
|