Ask Experts Questions for FREE Help !
Ask
    evision's Avatar
    evision Posts: 1, Reputation: 1
    New Member
    		  
    #1

    Sep 22, 2009, 06:51 PM
    79 dodge truck electronic ignition wiring
    Just got truck, alt. spiked melted red wire that goes to resistor block. Fixed wire but cannot get coil to fire now. What does this usually burn out in the electronic ignition?
    TxGreaseMonkey's Avatar
    TxGreaseMonkey Posts: 16,761, Reputation: 5597
    Uber Member
    		  
    #2

    Sep 22, 2009, 07:26 PM

    . Test all under hood and under dash fuses with a test light or multimeter:

    https://www.askmehelpdesk.com/cars-t...tml#post252145

    . Check the Ignition Control Module.
Not your question? Ask your question View similar questions
 

Question Tools Search this Question
Search this Question:

Advanced Search

Add your answer here.


Check out some similar questions!

Need Help on Dodge Truck Wiring [ 5 Answers ]

I was helping a friend install a siren in his dodge truck (volunteer Firefighter) and somehow the positive and ground touched and caused the horn, interior lights, and buzzer to deactivate. I checked all fuses in fuse block and all fuses and relays under the hood and they were all good with none...

Dodge truck wiring [ 2 Answers ]

I have a 2004 Dodge Ram 3500 Dualy. All the lights work on the truck but when I plug in trailer lights I don't get Left turn or left brake lights on the trailer only. I disassembled the receptacle and traced the wire to the bulk head with no faults found other than no power to the what I think is...

Dodge truck wiring problems [ 1 Answers ]

I have a 1992 Dodge Truck with a Cummins in it. The head lights went out in it the other day, but I still had marker and running lights. I purchased a new head light switch and installed it but now not only do I not have head lights but I have no running or marker lights. The warning buzzer...

Dodge truck wiring [ 19 Answers ]

I have a 1979 Dodge truck which will not charge. I have checked and rechecked connections, had the alternator checked by a garage I trust but they say it's OK . Are there any other typical problems which I may not know about? The Volt gauge (which I installed bypassing the old amp gauge) reads...

Dodge truck wiring question [ 1 Answers ]

I am working on a project Dodge truck. I want to wire the alternator without going through the ammeter. The harness I have has been modified before I got it and I have a question as to where the 3 wires on the alternator go. There is the normal, large black wire coming from the alternator which...

View more questions Search