Ask Experts Questions for FREE Help !
Ask
    fudail71's Avatar
    fudail71 Posts: 1, Reputation: 1
    New Member
    		  
    #1

    Sep 17, 2009, 11:16 AM
    Cadillac trunk won't close
    The motor at the bottom part of my 1988 fleetwood stays hot and the latch won't seem to grab the trunk and close it.
    CaptainRich's Avatar
    CaptainRich Posts: 4,492, Reputation: 537
    Cars & Trucks Expert
    		  
    #2

    Sep 17, 2009, 08:00 PM

    Try replacing the pull down switch. Very common.
    You may need to check what kind of screws are used. Some may be torx.
    Be careful. The plastic stuff will be brittle.
Not your question? Ask your question View similar questions
 

Question Tools Search this Question
Search this Question:

Advanced Search

Add your answer here.


Check out some similar questions!

1994 Caddy Trunk Motor Won't Close Trunk [ 7 Answers ]

Hi Guys, I have a 94 Caddy that the trunk closure motor,(see images) won't operate when the lid's closed. I've checked the 15 amp fuse and it's intact and not blown, Is there anything I've missed. Is there a override so I can close the trunk. I have a week before rain's forecast in my area but...

94 cadillac stalls [ 12 Answers ]

I have a 94 cadillac eldorado that stalls when driving and will immediately restart and run for 5 to 10 minutes and shuts down again. I replaced the ignition module with a good used one and no change. Also I tried to check to see if there was any codes by jumping a&b but nothing happens, is this an...

Cadillac cillanoid? [ 9 Answers ]

Hello all! I've got a 98 Deville that I love to pieces. Anyway, a while back, the service engine soon light came on and I took it to Aamco. Since I have a Northstar engine, the guys said they'd have to drop my whole engine to get to my tranny to even find the problem. Well I'm not made of money...

Gas line & dryer vent pipe - how close is too close? [ 1 Answers ]

I'm rerouting the gas dryer vent piping so that it will inside the adjoining stud wall. At the top of the wall the vertical exhaust pipe will be within an inch or two of the horizontal running copper gas supply line. Question - is there a minimum distance that the metal dryer exhaust pipe must...

View more questions Search