 |
|
| Browse | Ask | Answer | Search | Join/Login |
|
|
||||
|
How do I replace press handle spring
I have a craftsman drill press model #113 21371. The spring that pulls the press handle seems to be broken. There is a decal on the hub that says to see the operators manual for instructions in replacing or adjusting this spring. I do not have the manual and wanted to know if one is available or maybe someone would be knowledgeable to explain how to accomplish this task.
|
||||
|
||||
|
I think your in luck. Spring and an owners manual available from here: CRAFTSMAN | Model #11321371 | CRAFTSMAN 15-1 | SearsPartsDirect.com |
||||
| Question Tools | Search this Question |
Add your answer here.
Check out some similar questions!
This piece is made of plasic and broke off at the 90* neck angle. (at least it is stuck on shower mode which, if it had to break, is what I would prefer.) I have ID'd the part # but have a couple of quesitons about replacing it. First, how difficult is this for the average joe? I have a diagram...
The handle on my patio umbrella broke. When I removed the casing on the old handle, a spring popped out. The screw held the spring and lever against a gear to open and close the umbrella. Can anyone tell me how to put this back together?
I have a 2 handle shower faucet system. The hot water handle recently broke off just leaving the metal shaft with a phillips head screw at its end. If I turn this screw counterclock wise to remove it, the hot water turns on. What is my procedure to remove and replace this handle with a new one? ...
I needed to replace start pully on a ryobi 700r trimmer and the recoil spring came undone and now I can't get it back in. any suggestions?
View more questions Search
|
