 |
|
| Browse | Ask | Answer | Search | Join/Login |
|
Check out some similar questions!
Hi, I am renovating an old house and have decided to add a master bathroom. I currently have 1 (ea) 2 inch vent pipe penetrating the roof line. I'd like to branch off the single pipe and run several vent pipes off the single one mentioned above to vent two bathrooms, the kitchen sink, and...
I'm installing a wet bar sink in the basement and would like to tie into the drain (2”) that services the kitchen sink upstairs. It is about 5’ for the drain and I have no way to dry vent. Is it OK to use this drain as a wet vent and do I need to plumb the bar with a 2” drain because of the...
I am installing a whirpool tub that was roughed in for a end drain but the tub I have has the outlet on the side. I can raise it up so I have the correct pitch to the p-trap but will the inspector have a problem with this?
I have a two part question. 1.This is new construction and I have a question related to the venting. I have a 3” horizontal pipe installed between to floor joist. Attached to this pipe is a shower (seperate), bathtub(seperate) and toilet. This is how I have laid it out starting at the end of...
Hi All, I'm rebuilding a 1920's bathroom from the floor joist and studs, the question I have is the 1 1/2" Tub Over Flow ties into the trap which then ties into a 3" stack with a 3x3x1-1/2" Sanitary Tee. Do I need to install a vent in for the tub if the trap is 12" away from the stack? ...
View more questions Search
| Question Tools | Search this Question |
Add your answer here.
|
