Ask Experts Questions for FREE Help !
Ask
    elena99's Avatar
    elena99 Posts: 1, Reputation: 1
    New Member
    		  
    #1

    Sep 9, 2009, 04:23 AM
    Replace shower door
    We have a small fiberglass shower unit and the water is leaking out from under the door and now notice several screws are just floating and not holding the door on.. How do we buy a new door and attach it to the old shower?. do we make new holes for screws?
    Thank you Elena :)
    cyberheater's Avatar
    cyberheater Posts: 321, Reputation: 12
    Full Member
    		  
    #2

    Sep 11, 2009, 03:37 PM

    I need to understand your question.

    You want to buy a new door for the shower but try and fit it into the old frame? Is this a sliding door, or a regular door?

    Please give a bit more info. So I can help better.

    Thanks!
    creahands's Avatar
    creahands Posts: 2,854, Reputation: 195
    Ultra Member
    		  
    #3

    Sep 11, 2009, 04:44 PM

    U may be able to tap new screws to existing door. To get a new door may have to have it custom made.

    Do u have a drip edge on door?

    Chuck
Not your question? Ask your question View similar questions
 

Question Tools Search this Question
Search this Question:

Advanced Search

Add your answer here.


Check out some similar questions!

Replace garage door with wall? [ 4 Answers ]

Hi All, I have a small one car garage that is part of the basement. I want to remove the garage door and put in a wall with a door so that I can use this area as a workshop and as the primary entrance into the house during the winter. The other entrances are either up the steep driveway to the...

I want to replace a service door with a garage door [ 3 Answers ]

My garage runs into my basement. I only have one single car garage door. My basement wall is a block wall. My floor joist run parallel to the wall with my garage door. What I want to do is install a second single car garage door next to my existing garage door where a service door is located. ...

Replace jam french door [ 1 Answers ]

I'm trying to replace a section of jam on a french door that was made by peace door - - there are plugs in the jam when you take the plug out the is like a screw or something -- looks like the end of a allan wrench how do these work and how do you get in the hole to trun it - - I tried deep well...

Replace shower Plumbing Valve assembly shower head 2 knobs [ 3 Answers ]

In a fiberglass corner shower shell. What I have is an old leaking rusted Shower valve assembly. It leaks from the Shower head that is a hand sprayer with a wall mount from the sprayer. It also leaks around the both the hot and cold water wall mount knobs. The cold water knob the sleeve that...

View more questions Search