Ask Experts Questions for FREE Help !
Ask
    stikit100's Avatar
    stikit100 Posts: 3, Reputation: 1
    New Member
    		  
    #1

    Oct 27, 2006, 01:37 AM
    b&s flywheel
    The flywheel on my briggs looks like its been under water for ages it real rusty can anybody tell me the best way to clean it without doing any harm .the flywheel is removed so I want to clean inside and out
    thebriggsdude's Avatar
    thebriggsdude Posts: 1,096, Reputation: 53
    Ultra Member
    		  
    #2

    Oct 27, 2006, 10:18 PM
    Does it have a stator under the flywheel? Then just a wire brush, sand paper, wire wheel, etc will do.. if it has one, just try to clean the stator the best you can by hand, the outside, go crazy.. won't hurt it.
Not your question? Ask your question View similar questions
 

Question Tools Search this Question
Search this Question:

Advanced Search

Add your answer here.


Check out some similar questions!

20 AMP Circuit with 15 AMP Receptical, is this OK, and in code? [ 5 Answers ]

This is sort of similar to the other thread, but my problem is the house I bought is wired with 12, all the breakers are 20AMP except for the 30AMP for the AC and Dryer. When me and my dad were changing the power recepticals, which were 15 amp, someone told us that we should have 20 recepticals, or...

Correction-GFI & AFI Breakers & Shared Neutrals [ 3 Answers ]

I need to submit a correction to some advice I had furnished in the past regarding Ground Fault and Arc Fault circuit breakers being used on shared neutrals. I had in mind the typical single pole 120 volt breakers that will not work if two breakers are used for two 120 volt circuits that share a...

Flywheel won't turn [ 27 Answers ]

Ok, Yardman is several years old (I believe about about ten years or so) but I have had it a few months. Worked fine for awhile. Last few times I would cut it would cut for a good while then it would just cut off. Battery is weak so I would always have to jump it off beforehand. No problem with...

Knock & Flow Stop at Hot Water only to Kit. Sink & D/W [ 3 Answers ]

At our kitchen sink we have a problem with the hot water flow. When the hot water is turned on full (a mixing faucet) either immediately or shortly after the water comes to a full stop simultaneously there is a knock. The water does not begin flowing until you turn off the water altogether. ...

View more questions Search