 |
|
|
 |
New Member
|
|
Aug 19, 2009, 06:35 AM
|
|
1992 Honda Civic cranks but won't start. No spark!
My car died. It has no spark. I have changed the following parts to resolve this issue with no luck:
Distributor(all internal parts are new)Coil, ICM, everything.
ECM
Main Relay
I checked my MAP Sensor, and it is getting between 3 and 5 volts. I ran a jumper wire to get the codes out of my computer, and my check engine light comes on and stays on. It doesn't even give me the initial blink to let me know there is communication. It has done this on the old ECM, and the new one. I am getting 12 volts to my ECM, so I don't know what else it could be. My timing belt is fine. What else could it be? Please help me!
|
|
 |
Uber Member
|
|
Aug 19, 2009, 06:45 AM
|
|
. Test all under dash and under hood fuses with a test light or multi-meter:
https://www.askmehelpdesk.com/cars-t...tml#post252145
Be very thorough or you'll waste a lot of time and money. Pay particular attention to the ACG (ALT) (S) fuse, in the under dash fuse box.
. Clean the main ECM ground (brass connector) on the thermostat housing.
. Check/replace the ignition switch for wear, pitting, or melting:
https://www.askmehelpdesk.com/cars-t...tml#post224652
Does the new ECM's part no. exactly match the old one's?
|
|
 |
New Member
|
|
Aug 21, 2009, 09:00 PM
|
|
I checked the ignition. It is good. No cracks or pitting. I cleaned the main ground, and placed it all back together. Still nothing. My computer matches all numbers. All the fuses are good. Anymore advice?
|
|
 |
Uber Member
|
|
Aug 21, 2009, 09:05 PM
|
|
Did you meticulously check ALL under dash and under hood fuses with a test light or multimeter?
|
|
 |
New Member
|
|
Aug 22, 2009, 11:12 AM
|
|
I used a multi-meter. I checked every fuse. Are there fusible links that I should be worried about?
|
|
 |
Uber Member
|
|
Aug 22, 2009, 12:36 PM
|
|
No.
|
|
 |
New Member
|
|
Aug 28, 2009, 06:24 AM
|
|
My MAP Sensor is getting 5 volts. However, isn't the "signal" wire supposed to show voltage while you are cranking the engine? There is no variation on any wire while I am cranking. None of my vacuum lines are plugged.
|
|
 |
Uber Member
|
|
Aug 28, 2009, 06:26 AM
|
|
There's no need to worry about the signal wire voltage. It will fluctuate, based on the operating needs of the engine.
|
|
 |
New Member
|
|
Aug 28, 2009, 10:45 PM
|
|
What significance is it that my check engine light won't blink codes when I put a jumper wire in the Two-Wire connector under the passenger's side of the dash? It doesn't even blink once. As soon as I put in the jumper and turn on the key, it goes on and stays on.
|
|
 |
Uber Member
|
|
Aug 29, 2009, 06:30 AM
|
|
Likely, it just indicates no codes are stored in the ECM.
|
|
 |
New Member
|
|
Oct 26, 2009, 03:03 PM
|
|
I solved the problem, finally. It ended up being the distributor after all. I bought a remanufactured one from AutoZone, and it was bad. I bought a brand new one from O'Reillys, and it fired right up. That really was a pain in the rear. I have never bought a bad part before, so I assumed that it was good. Now I know in the future. Thank you for all of your advice. It is greatly appreciated.
|
|
 |
Uber Member
|
|
Oct 26, 2009, 05:13 PM
|
|
Yes, over 50% of all new aftermarket distributors for Hondas at AMHD have been bad. Of those that initially worked, many failed in subsequent months.
|
|
Question Tools |
Search this Question |
|
|
Add your answer here.
Check out some similar questions!
1992 Honda Civic won't start, no spark, lotsa $$ and time
[ 20 Answers ]
BRAND NEW member here, I feel very lucky to have found this site and am hoping for some guidance!
I've followed virtually every shred of advice I've read on this site in trying to fix a 92 Civic... checked and replaced the main relay (got new one at Honda dealer parts counter), the ECM (put in...
1992 Honda Civic DX no spark
[ 6 Answers ]
I just found this site and it is great. I do have to say, you all are more then willing to help everyone.
I just got a 1992 Honda civic DX, 1.5L Auto, 200K miles from a friend for nothing. It sat for two years but I was able to get it running and it ran good. After I changed the alternator,...
93 civic dx cranks but won't start, no spark after mpfi swap
[ 1 Answers ]
Yes I know there're a few topics something 'bout this.
But I made all the troubleshooting steps.
My civic came with dpfi I/m, and I swapped to an MPFI.
What I changed: ECM (PM6 from d16a6 fourth gen civic)
Distributor (td 02u from d16a6 too)
...
View more questions
Search
|