Not your question?
Ask your question
View similar questions
Add your answer here.Check out some similar questions!
Tile shower wall to cultured marble base transition
[ 3 Answers ]
I have a cultured marble shower base without the usual 3/8" lip along the edges; it's just a flat surface. All of the information I've found so far for transitioning between the backer board and shower pan with a tile wall include the lip in the diagram. I'm wondering without the lip should the...
Cost of adding an archway to an interior wall
[ 3 Answers ]
I am looking at installing an archway in a non-loadbearing wall between two bedrooms. I was given an estimate of $650.00 by an independent contractor. Does this sound reasonable?
Pouring a concrete wall in front of a damaged cinder block wall
[ 1 Answers ]
I need to repair a well house that has buckling cinder block walls. The well is below ground with a shed above it. The room is approximately 9' x 8' and 8' tall with cinder block walls and a concrete floor. The block did not have concrete poured in it when it was built, the blocks are beginning...
Adheering brick veneer to interior painted masonry wall
[ 3 Answers ]
I live in 1937 era Washington DC Rowhouse and I've been considering installing the bring veneer on my longest interior wall. The wall in question is masonry(painted). I have seen the instructions for a few of the brick veneer companies and they mention using a lathing system or using mortar in the...
Painted block wall blistering
[ 3 Answers ]
A few years ago I had a stuccoed block wall built, after a couple of months I painted the wall with an exterior grade latex paint,the wall paint showed lots of small cracks after a couple of months. So then I repainted with a rubberized paint and now the paint is blistering wherever my neighbours... View more questions Search
|