Ask Experts Questions for FREE Help !
Ask
    jenn123's Avatar
    jenn123 Posts: 4, Reputation: 1
    New Member
     
    #1

    Aug 7, 2009, 02:19 AM
    Cushion flooring
    I have had cushion flooring fitted in my kitchen/dinning room for about 18mths and it has started to bubble and crease up, so we lifted th floor up and the floor is damp we have checked all near by water source but no leeks. There are no water source with in 2m can not figure it out. Does cushion flooring sweat :confused: floor fitter said no point in glueing floor because we need to find out where damp is coming from
    ac101's Avatar
    ac101 Posts: 463, Reputation: 57
    Full Member
     
    #2

    Aug 7, 2009, 02:24 AM

    What type of subfloor do you have?
    jenn123's Avatar
    jenn123 Posts: 4, Reputation: 1
    New Member
     
    #3

    Aug 7, 2009, 02:29 AM

    It is concrete, the floor fitted leveled it of with screed!
    ac101's Avatar
    ac101 Posts: 463, Reputation: 57
    Full Member
     
    #4

    Aug 7, 2009, 02:31 AM

    What brand of cushion floor did you have installed ?
    jenn123's Avatar
    jenn123 Posts: 4, Reputation: 1
    New Member
     
    #5

    Aug 7, 2009, 02:38 AM
    Don't no, didn't know there was different types? Just thickness its about 4-5mm
    ac101's Avatar
    ac101 Posts: 463, Reputation: 57
    Full Member
     
    #6

    Aug 7, 2009, 02:40 AM

    Is it a cushioned vinyl ? What part of the world are you in ? US, UK ?
    ac101's Avatar
    ac101 Posts: 463, Reputation: 57
    Full Member
     
    #7

    Aug 7, 2009, 03:01 AM

    Ok here we go the reason I was asking about it being vinyl is that there are different types of products in different parts of the world. As far as the wetness goes either you have an external leak like a supply valve,drain line etc. or you have a pipe inside your concrete floor that is leaking or the concrete screed you used to level out your floor wasn't completely dry when floor was installed or you have natural moisture from outside wicking up through your concrete. Climate could have an effect on this ? Post back and tell us what you think. GOOD LUCK, AC
    jenn123's Avatar
    jenn123 Posts: 4, Reputation: 1
    New Member
     
    #8

    Aug 7, 2009, 03:13 AM
    Sorry if I sound a bit thick it is vinyl:-) I from uk, there is no drains or valve or pipes going across floor I used to have laminete flooring before this had no probs with that?
    ac101's Avatar
    ac101 Posts: 463, Reputation: 57
    Full Member
     
    #9

    Aug 7, 2009, 03:13 PM

    Is the floor pulled up now?
    21boat's Avatar
    21boat Posts: 2,441, Reputation: 212
    Ultra Member
     
    #10

    Aug 7, 2009, 08:24 PM

    I see this a concrete moisture problem wicking into the concrete. We do a preliminary cheap test for moisture in a concrete floor. Cut a piece of 6 mil plastic 24"x24". Lay it on the floor and duct tape the edges. If there is any water droplets in 24 hrs then there is 5% of moisture in it. Not Good the more accurate test is this and is in your neck of the woods before the U.S.

    ASTM F2170-02: A Concrete Moisture Testing Method for the 21st Century - Column - National Floor Trends
    Test is and let me know..
    ac101's Avatar
    ac101 Posts: 463, Reputation: 57
    Full Member
     
    #11

    Aug 7, 2009, 08:33 PM

    Good job boat that's the same problem I suspect can't figure why it didn't show up with the previous flooring though. AC
    21boat's Avatar
    21boat Posts: 2,441, Reputation: 212
    Ultra Member
     
    #12

    Aug 7, 2009, 11:13 PM

    Like people all floorings are not the same. Add to that the different environments they all get put in. More so then not it the location/installation problems.

    Take for instance Armstrong's designer inter-flex solarium's. "floor with a Memory" Glue side 4" seams 6" pull tape off sheet good install. Shrinks over night and tightens. BUT the Armstrong's glue to glue it down is a number/letter off for a below grade installation. It's the fine print

Not your question? Ask your question View similar questions

 

Question Tools Search this Question
Search this Question:

Advanced Search

Add your answer here.


Check out some similar questions!

Laminate flooring transition to raised vinyl flooring [ 4 Answers ]

Installer put new 1/4' subfloor in bathroom last year when installing new Tarkett (vinyl) flooring, with a metal strip transition to existing hall carpet. Now we are installing 12mm laminate in hall, which with underlay, is approximately the same height. However, when the metal strip was removed,...

Escrow cushion [ 1 Answers ]

How is an escrow cushion figured in Minnesota? How much should it be? My Taxes are $1270 twice a year and house insurance is $1069 once a year. Thank you for your reply.

Is Underlayment needed for Vinyl over screwed cushion tile [ 2 Answers ]

Last year I installed a floating Formica glued laminate floor in my kitchen over a cushioned vinyl tile original floor. Six weeks later an upstairs commode ran over while we were away and flooded the kitchen floor. The insurance company had the floor dried out and all appeared well for a few...

Flooring [ 3 Answers ]

Squeeky chipboard floor solutions please


View more questions Search