Ask Experts Questions for FREE Help !
Ask
    subsailor20's Avatar
    subsailor20 Posts: 3, Reputation: 1
    New Member
    		  
    #1

    Jul 26, 2009, 09:26 AM
    Shower divertor valve constant pass through
    I have a three valve tub/shower valve set. The center valve is a diverter valve.
    This valve has a pass through leak, not out of the stem. I have been unable to determine the mfgr but must remove the valve to complete this search.

    I have not been able how to accomplish the valve removal. If a picture would help I could do that.

    Thanks for the info.
    hkstroud's Avatar
    hkstroud Posts: 11,929, Reputation: 899
    Home Improvement & Construction Expert
    		  
    #2

    Jul 26, 2009, 09:46 AM

    Yes a pic would help, show us.
    massplumber2008's Avatar
    massplumber2008 Posts: 12,832, Reputation: 1212
    Senior Plumbing Expert
    		  
    #3

    Jul 26, 2009, 09:51 AM
    Hey Subsailor...

    Here's a quick pic... should help.

    MARK
    Attached Images
     
    subsailor20's Avatar
    subsailor20 Posts: 3, Reputation: 1
    New Member
    		  
    #4

    Jul 27, 2009, 05:18 AM
    Quote Originally Posted by hkstroud View Post
    Yes a pic would help, show us.
    I have attached a picture of the installed diverter valve and one of the external components.

    Thanks for the response.
    Attached Images
      
Not your question? Ask your question View similar questions
 

Question Tools Search this Question
Search this Question:

Advanced Search

Add your answer here.


Check out some similar questions!

Stuck middle valve - 3 handle shower valve [ 3 Answers ]

Help and suggestions!! The middle handle, used to divert water from the tub spout to shower head is stuck in the 'tub' position. I have removed the handle and trim bezel and tried to turn the shaft with pliers - no luck & quit before marring the splines on the brass shaft. What now??

Shower temp not constant [ 6 Answers ]

I have a new (Jan '06) 55 gallon Marathon electric water heater in my townhouse. Works great except when showering. After about 2-2 1/2 minutes in shower, water starts getting cooler and cooler. If I turn the mixing valve more towards hot, the hot water returns but again only for a minute or two...

Replace shower Plumbing Valve assembly shower head 2 knobs [ 3 Answers ]

In a fiberglass corner shower shell. What I have is an old leaking rusted Shower valve assembly. It leaks from the Shower head that is a hand sprayer with a wall mount from the sprayer. It also leaks around the both the hot and cold water wall mount knobs. The cold water knob the sleeve that...

Showerm Divertor [ 1 Answers ]

How To Replace And Remove Shower Stem Divertor

Shower mix valve [ 1 Answers ]

Hello, I have a one valve tub hot water / shower mixer. You pull it out to get water out of faucet and than lift a deverter thing (similar to a sink drain closer_ to get the water to come out of the shower. The faucet is dripping . I believe it is the rubber end of the stem inside the valve. I...

View more questions Search