Ask Experts Questions for FREE Help !
Ask
    Leannbe's Avatar
    Leannbe Posts: 1, Reputation: 1
    New Member
    		  
    #1

    Jul 16, 2009, 05:24 PM
    Hot tub wiring
    How much does it cost to hardwire a hot tub
    Dr_Spa's Avatar
    Dr_Spa Posts: 101, Reputation: 13
    Junior Member
    		  
    #2

    Jul 16, 2009, 09:32 PM

    $20 -$20,000

    :-)

    There;s way to many variances to answer this.
    Stratmando's Avatar
    Stratmando Posts: 11,188, Reputation: 508
    Uber Member
    		  
    #3

    Jul 17, 2009, 04:57 AM

    You need to factor in How long it Takes to run the conduit, Crawl through the attic, under the house, GFI protection, 120 volt 20 amp, 240 Volt/60 amps, pulling the wire, any trenching. Basically add up the Hours in labor to acccompolish the above and the cost of materials.
    If someone ran the conduit through attic, or trenched for me before I got there, it would not hurt my feelings, and would save you money.
Not your question? Ask your question View similar questions
 

Question Tools Search this Question
Search this Question:

Advanced Search

Add your answer here.


Check out some similar questions!

Wiring direction for a multi wiring system thermostat! [ 3 Answers ]

I have a 2 wire system (3 phase), need to connect multi wiring system thermostat! Need to know if, its correct to just use line#1, and the device already has a jumper?

Janitrol wiring to rth3100c wiring [ 1 Answers ]

I've taken off the cover and the wires are all OK but the black one where does it go to? My heater won't come on (well some times the AC come on with out me turning it on.)

Honeywell wiring different from old thermostat wiring [ 2 Answers ]

I purchased a non-programmable digital thermostat to replace an analog thermostat with wiring red, white yellow and black. How do I match the wiring? HELP!!

John Deere - My dog ripped the wiring Out - Need Wiring Diagram or photos [ 2 Answers ]

I have a 3 year old L110 that ran fine until last week. I think my dog chased a chipmunk up under the hood and in trying to get to him ripped a bunch of wires out. I have spliced back together the obvious wires (color coded) but I have one black wire that I assume is a ground(?) and the two...

View more questions Search