Ask Experts Questions for FREE Help !
Ask
    ListnerME's Avatar
    ListnerME Posts: 1, Reputation: 1
    New Member
    		  
    #1

    Jun 30, 2009, 04:22 PM
    Water pressure
    We keep losing water pressure and then we reset the pressure gauge to start it will gain pressure but when we use the water it drops to 0 again. We replaced the well troll pressure gauge it seemed to help but then started all over again! What could the problem be?
    jlisenbe's Avatar
    jlisenbe Posts: 5,020, Reputation: 157
    Uber Member
    		  
    #2

    Jun 30, 2009, 06:47 PM

    Need a little more info.

    1. Is your pump in the well or above ground?
    2. When you say you reset the gauge, I assume you mean you reset the switch by moving the little lever on the side?
    3. Is your area undergoing a period of low rainfall at this time?
Not your question? Ask your question View similar questions
 

Question Tools Search this Question
Search this Question:

Advanced Search

Add your answer here.


Check out some similar questions!

New hot water heater installed, but no hot water pressure. Plenty of cold water? [ 11 Answers ]

Hi, I own a small plumbing service and have a problem I've never encountered before. I installed a new top vented gas water heater for a customer. Turned the main back on, bled air out of the lines, etc. Problem is there is no hot water pressure throughout the house. Cold water pressure is fine....

Cold water pressure is lower than Hotwater pressure [ 1 Answers ]

In the bathroom sink, I see the hotwater pressure is very good . When I open the cold water it is very low. It is was fine 2 weeks ago. What could be the problem? Thanks Asaad

Low water pressure causing high blood pressure [ 1 Answers ]

I have low or no hot water pressure to the downstairs bathroom. I've replaced the cartridges, valves and hot water heater, still no pressure... help.

View more questions Search