Ask Experts Questions for FREE Help !
Ask
    jcmoreno's Avatar
    jcmoreno Posts: 1, Reputation: 1
    New Member
    		  
    #1

    Jun 25, 2009, 06:12 PM
    Bonding to vikrell
    I purchased a new 4 piece shower unit from Sterling. I drilled the wrong side wall. Now I would like to bond the whole with the piece from the correct one. What do I use as a glue.
    ballengerb1's Avatar
    ballengerb1 Posts: 27,378, Reputation: 2280
    Home Repair & Remodeling Expert
    		  
    #2

    Jun 25, 2009, 06:18 PM

    Before you try to patch try calling Kohler and tell them your story. I wrecked a shower door track and they gave me a new one free. Plead dumb, it worked for me and I am only a little dumb. Sterling Plumbing: Bathroom and Kitchen Products, Shower Doors, Baths, Showers, Toilets, Bathroom Sinks, Kitchen Sinks
Not your question? Ask your question View similar questions
 

Question Tools Search this Question
Search this Question:

Advanced Search

Add your answer here.


Check out some similar questions!

Surface crack in new Vikrell shower wall [ 1 Answers ]

I just bought and installed a new replacement (4-piece) Sterling shower unit with Vikrell walls. A slight surface dimple/indentation (5 mm in diameter) was discovered on one of the walls after installation was complete. The crack has not gone all the way through the shower wall. How can I...

Bonding [ 2 Answers ]

My friend and I are starting an in-home consumer electronics consultation business. Should we be bonded for that. We will probably not be doing a lot of installation ourselves but will be contracting. Yet, I see us getting involved a little at least to some degree.

Bonding [ 2 Answers ]

How do I get bonded on a job?

Bonding [ 2 Answers ]

My question is: I have heard that the government will bond a felon for six months free of Charge to an empolyer does anyone know about this subject

Bonding [ 1 Answers ]

I am going to replace a 60amp meter base with a 100amp meter base with an outside disconnect. The main service breaker box is already a 100 amp. The question is, if I ground the outside disconnect and run 4 wire to the main pannel should the main pannel stay bonded like it is now?

View more questions Search