Ask Experts Questions for FREE Help !
Ask
    jbox1973's Avatar
    jbox1973 Posts: 1, Reputation: 1
    New Member
     
    #1

    Jun 23, 2009, 07:54 PM
    Blower works on heat butnot a/c
    On my central unit the heat works fine but turn on the a/c the blower motor won't come on. I replaced the relay.
    hvac1000's Avatar
    hvac1000 Posts: 14,540, Reputation: 435
    Heating & Air Conditioning Expert
     
    #2

    Jun 24, 2009, 03:41 AM
    It could be the

    Thermostat
    Thermostat low voltage wiring
    Defective circuit board if one is used in the system

    These three will be a good start.

Not your question? Ask your question View similar questions

 

Question Tools Search this Question
Search this Question:

Advanced Search

Add your answer here.


Check out some similar questions!

Blower will not work with a/c but works with heat [ 2 Answers ]

We have a coleman evcon blend air II furnace. The blower motor will not kick on when the a/c is turned on, but will kick on when switched over to heat. The outside unit is working. We have replaced the thermostat and a relay switch and still no fix. Any ideas?

Heat blower works ac blower won't shut off. [ 1 Answers ]

Hello, I am having trouble with my RTH230B Honeywell. I have a Gas furnace and an outdoor ac unit hooked up to a blower and the blower has a heat off cool setting on a switch on it. Our when set on heat everything works as it should. BUT as soon as I turn the blower to cool it turns on and...

Blower works on A/C but not on heat or fan only [ 1 Answers ]

I have a 1997ish intertherm A/C unit, when the Air is on the blower works fine, but when I switch to heat or fan only the blower will not work? I have bought a new blower relay & capacitors. I tested the sequencers for 240 & 24 volt, everything is reading good. I am at a loss, does anyone have...

Blower fan works in A/C but not heat [ 8 Answers ]

A couple of weeks ago my Lennox G20Q3E-75-1 was acting up. Gas valve was cycling when calling for heat and then once satisfied and the main burners went out the pilot light was staying lit. I thought it might be the flame sensor as far as the gas valve cycling and didn't want to tear into it so I...


View more questions Search