Ask Experts Questions for FREE Help !
Ask
    JOBrien's Avatar
    JOBrien Posts: 1, Reputation: 1
    New Member
    		  
    #1

    Jun 23, 2009, 05:08 PM
    Kenmore dishwasher not filling w water
    I have a Kenmore ultra wash dishwaster that is about 5-6 years old, model #665. I can push the buttons to start it and it acts like it's going to start, but is not filling up with water. Any suggestions thanks.
    hvac1000's Avatar
    hvac1000 Posts: 14,540, Reputation: 435
    Heating & Air Conditioning Expert
    		  
    #2

    Jun 25, 2009, 03:48 AM
    Check the water fill valve for proper operation.
    Marionforrest.'s Avatar
    Marionforrest. Posts: 1, Reputation: 1
    New Member
    		  
    #3

    Nov 6, 2011, 03:51 PM
    KenmoRe dish washer not filling with water
Not your question? Ask your question View similar questions
 

Question Tools Search this Question
Search this Question:

Advanced Search

Add your answer here.


Check out some similar questions!

Kenmore Dishwasher Still has water in it when finished [ 2 Answers ]

Hello: I have a Kenmore Type 575-0 Model 665.743823 that is about 3 years old. For the past 6 months or so the glasses always have dirt on the inside of them when the load has finished. For the past week, when the load is finished, the bottom of the washer is full of water. If I press the...

No water on top rack of Kenmore dishwasher [ 2 Answers ]

I have a 3 yr old Kenmore dishwasher that is not spraying any water on the top rack. I have already disassembled the upper wash and rinse parts and verified they were not plugged up. Is there anything else I can check before calling in the repairman?

Water supply for a kenmore dishwasher [ 1 Answers ]

I purchased a new Kenmore dishwasher, (Consumer Report # 1 rated if that helps). I do not have the model number handy, however, does it normally require a hot or cold water supply? Thanks in advance

Kenmore dishwasher won't heat water [ 3 Answers ]

I have a new Kenmore Elite dishwasher. I have checked the water during the Hi Temp wash cycle and the sani rinse cycle and it isn't any hotter than 133 degrees, the temp of the water from my water heater. The instructions say the water should be at a minimum of 129 from the tap and I always run the...

View more questions Search