Ask Experts Questions for FREE Help !
Ask
    KISS's Avatar
    KISS Posts: 12,510, Reputation: 839
    Uber Member
    		  
    #1

    Jun 22, 2009, 08:50 AM

    <post moved to its own thread>

    Check safety switches, particularly the seat switch.
    ballengerb1's Avatar
    ballengerb1 Posts: 27,378, Reputation: 2280
    Home Repair & Remodeling Expert
    		  
    #2

    Jun 22, 2009, 11:55 AM

    Looks like to actual question did not quite make the move but I know what you were asking. Seat switches do go out the most quick so KISS got you started in the right place. Do you know where that switch is located and how to check it?
Not your question? Ask your question View similar questions
 

Question Tools Search this Question
Search this Question:

Advanced Search

Add your answer here.


Check out some similar questions!

Craftsman riding mower engine stops when blades are engaged [ 15 Answers ]

I have a Craftsman 'Garden Tractor', model number: 917.273070. It has a Kohler engine (model number: CV22S, type number: 75534). The engine starts fine and will run without any issues in all gears. However, immediately once I engage the blade clutch the engine begins to stall. If I place the...

Troy-Bilt Lawn Tractor stops moving, engine/blades still on. [ 1 Answers ]

I have a Troy-Bilt Pony, 17.5hp, 8-Speed, 42" Lawn Tractor. At start of the season, started mowing and after approx. 45 minutes, the mower just stopped moving. I disengaged the blades, tried to change speed, direction, and every time I released the clutch/brake pedal, the engine pulley would...

Mtd stops in 7th gear [ 1 Answers ]

My mtd slows down and then comes to a stop while going up hill. When shifted into 2nd or 3rd gear it will go. Belt was replaced a year ago, problem has been getting worse sense belt replacement. Can anybody explane how to adjust the belt or clutch . The unit is a 14.5hp 42" 7speed mtd yardman.

Blades won't engage in high gear. [ 4 Answers ]

I have a 2001 Troybilt tractor, 23hp with a 50" cut. It runs great and blades engage and cut in low gear. However when in high gear the blades disengage. Anybody got any idea on what could be the problem? Email me please @ [email protected]. Thanks

View more questions Search