Not your question?
Ask your question
View similar questions
Add your answer here.Check out some similar questions!
Wiring up a new blower motor for my furnace
[ 6 Answers ]
I have a Rheem furnace that is at least 10 years old, could be as old as 20. I had to replace the blower motor which was a 1/4 hp and the motor I replaced it with was able to be 1/8, 1/4 or 1/2 hp. Depending on how it is wired. From reading on the capacitor I could hook this up as a 1/2 hp which...
Wiring blower motor relay
[ 7 Answers ]
My blower motor relay burned out and I replaced it with a universal relay. It has R, G, W, Y, and C. I got the wiring right for the furnace but I don't know where the wires for the air compressor go. The wires from the compressor are red, white, green and blue. I put the red wire on the W and the...
Furnace blower motor wiring
[ 2 Answers ]
I have an old furnace blower that I want to convert to a shop air clearner. I want the motor to operate from a normal 110 volt switch. My question is which wires do I connect to the switch? The motor is a 1/2 hp Emerson Model K55HXLGG3702 It has 6 wires - black, white, brown, blue, red, yellow
Wiring for motor relay in AC
[ 10 Answers ]
We have a Rheem gas furnace/central AC system. The blower motor went out. We finally found a new one. However... I was stupid and did not draw the wiring diagram when I disconnected the old one. Now I can't seem to figure out how to rewire everything. There is a relay switch on the side... View more questions Search
|