[JayDubb]

I'm adding a Bedroom and a music room in my basement. I was informed that a Cap Plate in not needed. I've completed 1 wall with Top and Bottom Plates and toe nailed in the 2x6's is this method okay for code?

[skiberger]

2x3's can be used for non-load bearing walls and meet code. 2x6 in a non-load bearing is overkill.

You don't need a top plate in a basement non-load bearing situation. All your doing is framing out walls.

[honeyhunter2006]

I'm adding a Bedroom and a music room in my basement. I was informed that a Cap Plate in not needed. I've completed 1 wall with Top and Bottom Plates and toe nailed in the 2x6's is this method okay for code?

If they are not load bearing walls, then there is no real need to use a cap or to plate. If you have room, build the wall laying down on the floor and stand them up into place, as this is much better than toe nailing them together and will speed up production. Build them about 1/2 shorter than the actual height and that will give you plenty of room to set them into place. A few shims at the top and you are good to go! It is also wise to use a pressure treated 2x4 for the bottom plate that comes into contact with the concrete.