Craftsman tractor lawnmower;blade belt replacement

lawny Posts: 1, Reputation: 1

New Member

May 25, 2009, 09:40 AM

Craftsman tractor lawnmower;blade belt replacement

Trying to get the belt around the brackets that hold the deck

ballengerb1 Posts: 27,378, Reputation: 2280

Home Repair & Remodeling Expert

May 26, 2009, 08:26 AM

Which belt are you replacing, there are 3.

Add your answer here.

Check out some similar questions!

Craftsman LT1000 blade belt replacement [ 1 Answers ]

The LT1000 blade overheated and broke, probably from grass accumulation. I purchased a 42" Craftsman belt to replace it, but I cannot located the procedure to get the belt back on all the pulleys... HELP PLEASE

Craftsman Yard Tractor - Blade Belt Tension Spring [ 1 Answers ]

Hi all, Please help me, I do not have the owner's manual, I have tried to go to sears.com and can not get the model tab to work. Question: Where does the spring mount to on each end, for the belt tension pulley, for the blade belt? The model # is 917.255820, 44" deck, 16 HP Thanks in advance.

Craftsman tractor belt replacement [ 1 Answers ]

I have a Craftsman II OHV Gold 12.5hp Model number 917.254750 the old belt fell apart and I cannot figure out how to install the new belt. Could someone send me in the right direction or tell me how to replace the belt? Thanks for your time. Donald

Craftsman lawn tractor blade belt replacement [ 2 Answers ]

Okay, how do I get the belt onto the pulleys? Is there something I need to do with the deck? This is a craftsman 14hp lawn tractor model #917-255694. Is there a website that I can download the picture or instructions from a manual? I am having trouble trying to figure out how to get the belt...

Removing a blade from a Craftsman Lawnmower... [ 4 Answers ]

Okay I am trying to tighten up the blade on a Craftsman electric lawnmower my neighbor threw out. It still works, but the blade will not tighten up. I have tried to hold the blade and loosen, held the spinning mechanism the blade sits on, I have jammed screwdriver up into the bottom of the mower...