Information about Murray Lawn Mower

Jaye Toler Posts: 1, Reputation: 1

New Member

May 11, 2009, 11:30 AM

Information about Murray Lawn Mower

I have a Murray Riding Mower and cannot get blades to engage, does not have broken belts or anything like that

ballengerb1 Posts: 27,378, Reputation: 2280

Home Repair & Remodeling Expert

May 12, 2009, 08:49 AM

What happens when you move the handle to engage the blades?

Add your answer here.

Check out some similar questions!

Murray rideing lawn mower [ 5 Answers ]

I can not get it to start, it will start with starter fluid and dies. I do not know how to remove the carb to clean it, can you advise and do you think this is the trouble. It has set up for a good little bit.

Murray Lawn Mower will not start [ 2 Answers ]

I have Murray Lawnmower that will not start. The engine will turn over slowly, almost like the battery is drained or dead. I have tried to jump it off and have changed the battery and it did not help. I had to replace the silenoid earlier in the year and have not had any problems until now. ...

Murray Lawn Mower will not start [ 3 Answers ]

Hello everybody, I bought this lawn mover 4.5 hp about a 1 1/2 years ago from someone else. It was practically new when I bought it. The guy decided to sell it because he sold his house and was moving to a condo. I used it for like 1/2 a year and then put it in storage for a year. When I got it...

Murray Lawn Mower Bags [ 2 Answers ]

I have a Murray 11/36 riding lawn mower probably 20+ years old, and need the leaf bags that will fit it. The unit # on the assembly bracket is 8-24336. The tractor model # is 8-36555?? Last 3 #s are missing

Murray Lawn Mower dies [ 5 Answers ]

Have Murray 20'' mover with 6.0 hp Quantum. It's about 5 years old. Yesterday it died while mowing tall grass. After that, it will start but only run for about 5 seconds before Dying again. Think oil and gas are OK. Tried removing the air filter but still dies. Tried it today with cold engine,...