Ask Experts Questions for FREE Help !
Ask
    kymtnman's Avatar
    kymtnman Posts: 2, Reputation: 1
    New Member
    		  
    #1

    May 7, 2009, 07:49 AM
    No sodder joints
    Is there a way to have so sodder joints when replaceing copper plumbing
    speedball1's Avatar
    speedball1 Posts: 29,301, Reputation: 1939
    Eternal Plumber
    		  
    #2

    May 7, 2009, 12:21 PM
    Quote Originally Posted by kymtnman View Post
    is there a way to have so sodder joints when replaceing copper plumbing
    Sure is! They're called SharkBite, They'll work on both copper and plastic (see image) check them out at;
    Welcome To Cash Acme
    Good luck, Tom
    Attached Images
      
Not your question? Ask your question View similar questions
 

Question Tools Search this Question
Search this Question:

Advanced Search

Add your answer here.


Check out some similar questions!

Ball joints [ 3 Answers ]

What would an estimated cost of replacing lower ball joints on my 1998 Ford F150? I called a fairly reliable repair shop this morning and they gave me an estimate of approximately $365. This would include labor and the alignment. I looked at NAPA online and found the lower ball joints at a...

Resoldering joints [ 6 Answers ]

I recently had trouble soldering some 3/4" rigid copper pipe joints. I had to hold the torch on the joint for 10-15 minutes before the solder flowed. Even then, it was not a good clean flow of solder into the joint. One joint had a pin-hold leak, now I can't heat that joint hot enough to separate...

$850 for ball joints? [ 4 Answers ]

I was told I need to redo the upper and lower ball joints on the front of my 98 Dakota... does this sound about right for this repair? I know something is wrong because I'm getting some vibration when I drive, especially at high speeds.

View more questions Search