Ask Experts Questions for FREE Help !
Ask
    cmvorwaller's Avatar
    cmvorwaller Posts: 1, Reputation: 1
    New Member
    		  
    #1

    Apr 23, 2009, 03:23 PM
    Repair/Replace PowerArm for Craftsman Tiller
    Craftsman Tiller model 917 299 370 (6 HP chaindrive 13" diameter tines) over 20 yrs old - Problem: the power arm that holds the tiller assembly and encases the drive chain, is broken. Can it be welded or do I need to get a replacement? Everything else in good working condition.
    ballengerb1's Avatar
    ballengerb1 Posts: 27,378, Reputation: 2280
    Home Repair & Remodeling Expert
    		  
    #2

    Apr 23, 2009, 04:21 PM

    Likely a good welder can fix it but if not thenuse the model number here to find a part. Parts & Accessories | Shop & Find Lawn & Garden, Appliance Parts at Sears PartsDirect | SearsPartsDirect.com
Not your question? Ask your question View similar questions
 

Question Tools Search this Question
Search this Question:

Advanced Search

Add your answer here.


Check out some similar questions!

Older Craftsman Tiller w/5hp Briggs and Stratton [ 11 Answers ]

I recently acquired an old tiller that I have gotten to run. It will only run on full choke. It will only till for about a minute or so before going dead. It will idle for a long period, but it's kind of a rough idle. Do I need to adjust the carberator? I have already changed out the gas and...

Craftsman Tiller parts [ 3 Answers ]

I have inherited my aunts craftsman tiller, 5HP 206 CC The Model No. is 917.298541 there is another number on it, 9561R My husband and I are wondering if there is any way we can determine the age of the tiller. We would also like to have a parts schematic. I hope you can help me. ...

Craftsman Tiller tines always running [ 2 Answers ]

I have a Craftsman 5HP tiller with reverse (Model# 917.299450) Searspartsdirect link I got the tiller from someone else and it was purchased in 1981 I believe. So its an old old tiller but it still runs and does the job. I replaced the forward motion v belt. The one I put on broke so I replaced...

How to replace starter rope on my Ariens tiller [ 3 Answers ]

The starter rope on my tiller broke and in trying to replace it, the recoil spring for the rope isn't accessible to rewind it so the rope will re wind . I hope the answer is simple and probably is , I just can't figure out how to get the starter cord replaced so I can use the tiller . Thank you for...

Craftsman Tiller [ 2 Answers ]

I have purchased a new carb already. 5.5 hp B&S. I think I damaged my old carb by using air pressure to clean out the old gas. The rubber seat under the needle came out and there is no way to get back in. Can this be repaired?

View more questions Search