Ask Experts Questions for FREE Help !
Ask
    oldjumper's Avatar
    oldjumper Posts: 1, Reputation: 1
    New Member
    		  
    #1

    Apr 14, 2009, 11:09 AM
    No start
    Hi I have a woods zero turn mower model5180. Mowed the yard couple of times starter stayed engaged a couple of times . Then no engageing at all, charged the battery, put on new regulator. Still won't do anything when turning key. The moter will start by jumping the regulator terminals. Thanks for any info Charles
    ballengerb1's Avatar
    ballengerb1 Posts: 27,378, Reputation: 2280
    Home Repair & Remodeling Expert
    		  
    #2

    Apr 16, 2009, 11:35 AM

    Can you describe what you mean by "engaged" just not sure what you are saying here.
    RANKSRAPC's Avatar
    RANKSRAPC Posts: 1, Reputation: 1
    New Member
    		  
    #3

    Apr 17, 2009, 03:47 PM
    I have a featherlite weedeater, it seems to getting enough gas the spark is good, the primer bubble after three presses stay compressed and refuses to start.
    ballengerb1's Avatar
    ballengerb1 Posts: 27,378, Reputation: 2280
    Home Repair & Remodeling Expert
    		  
    #4

    Apr 18, 2009, 05:33 PM

    RANKS if you have a question of your own you should click on ASK at the top of the page. Do not piggy back on someone else's post, it just con fuess us old guys.
Not your question? Ask your question View similar questions
 

Question Tools Search this Question
Search this Question:

Advanced Search

Add your answer here.


Check out some similar questions!

No HSI start GMNT Goodman Janitrol No flame start [ 1 Answers ]

I have a Janitrol (Goodman) furnace, and the controller board indicates 3 blinks. The flame blower starts, but it never gets to HSI (the ignitor never starts heating up). I've changed the controller board, and same issues. I've been through every sensor (bypassing all of them), and still no...

Lawn mower won't start , changed Plug , but Still won't Start [ 2 Answers ]

My lawn mower won't Start , I tried Changing the Plug , But still won't Start

Can't start my Poulan chainsaw. Start rope too hard to pull. [ 1 Answers ]

Can't start my chainsaw because the start rope is too hard to pull out. Pulling the rope causes a jerky action.

91 honda crx no start or rough start, puzzled HELP! [ 5 Answers ]

Ok, I'm running a SOHC ZC motor. I have good compressions across all pistons at 135psi and holding a piece. I have checked the timing and it is correct. I have checked the fuel pressure and it is OK. I haven't been able to figure out how to lean the fuel out though, but anyway, it starts up and...

View more questions Search