Not your question?
Ask your question
View similar questions
Add your answer here.Check out some similar questions!
Bryant 383kv won't light error code 14, what part do I replace
[ 7 Answers ]
The thermostat is calling for heat, 65 deg, the temperature is only 58 and furnace is in lock down showing error code 14. The furnace is a Bryant 383KAV. If I cycle the power to the furnace off and then on again, the furnace will start and run in a normal fashion. This has been happening more...
Bryant Plus 80 Code 33
[ 10 Answers ]
I have a Bryant Plus 80 that is throwing a error of 33 (limit or flame roll out switch is open). The last time this happened was because the hot surface igniter was broken (frequent problem as my furnace has a tendency to short-cycle). I had picked up a couple extra ones so I had them on hand to...
Bryant gas furnace
[ 1 Answers ]
I have a bryant gas furnace model 383kav038070. I get trouble shooting code 12. What has failed. I do not have code table
Bryant furnace: Replace Control
[ 2 Answers ]
The furnace shut reported a "Replace Control" code. I cut the power to the furnace and then restarted and it has been functioning normally for the past few hours. Can this furnace give false codes for any reason?
New Bryant A/C compessor will not run
[ 1 Answers ]
I have a newly installed Bryant 2 1/2 ton compressor unit that was installed in August 2005. When I turned on the A/C the unit would not start. I checked the disconnect near the compressor and found it to be faulty and replaced it with a new one and there is still no start up. I pulled the panel to... View more questions Search
|