Not your question?
Ask your question
View similar questions
Add your answer here.Check out some similar questions!
Advice needed on sizing/routing PEX lines
[ 10 Answers ]
I am beginning to replace the 53 year old copper lines in my house with PEX as I am building a bathroom in the basement. I want to put in a manifold to separate some of the lines and give a central location for shutoff controls. Running individual lines to every fixture could be a bit expensive...
Changing from copper to plastic water lines
[ 2 Answers ]
Hi All, I am trying to move the water supply lines for the bathroom so that I can begin framing a bathroom in the basement. The water lines are going right across the bottom of the floor joists where I need to put up the headers for the walls so I need to move them. My brother in law was...
Vanity Water Lines
[ 5 Answers ]
We are having a house built and the plumber ran the water lines up through the floor rather than through the wall. I have never seen this before. Is this common? I am concerned that the lines will not have the strength to support a shutoff valve? Are there any codes related to this issue? ...
Draining water lines before soldering
[ 2 Answers ]
I'm currently putting a bathroom in my basement. I'm ready to tie into my existing water lines. I need to know if I need to shut off and empty my water heat in order to drain the water out of the lines. The water heater is in the basement and would be lower than any faucet. I would prefer not to...
Air in water lines
[ 1 Answers ]
I have a on going problem with air in my water lines. When the outside water is turned on either the water comes in bursts or it is steady but with air bubbles. I have a horse farm and the water lines to my paddocks & barns froze and broke last winter (30 below 0 with no snow) so all of them were... View more questions Search
|