Not your question?
Ask your question
View similar questions
Add your answer here.Check out some similar questions!
1/2 to 3/4 new water heater bad hot pressure
[ 4 Answers ]
Hi, I just installed a new electric water heater, (energy smart), was told by whirlpool that increasing my hot out to 3/4 would be better pressure, previous was 3/4 in 1/2 out, well now it is hard to regulate the water, plenty of hot water but just turn cold a little too much and it takes over....
NEW water heater but no pressure
[ 8 Answers ]
I installed a new electric water heater. Had great water pressure before this install, now it takes forever for my washer to even fill up, I have to turn the knobs or water will just flow, so Not sure if the washer or water pressure. The pressure relief valve was leaking when installed, got a new...
Hot Water Heater Pressure Valve
[ 3 Answers ]
Every year when we go on vacation I turn the water off to the house. Last year we noticed that the carpet in the basement which is next to the closet that houses the hot water heater was damp after returning home and turning the water back on. We did not notice any water on the floor next to the...
Water heater pressure
[ 1 Answers ]
We added a new gas water heater, and after it was installed. The water pressure in the bathtub and bathroom sink wouldn't work. Can you tell me why and what to do to fix. Thanks
Low Hot Pressure w/NEW HW Heater
[ 1 Answers ]
We had the dreaded disintegrated intake tube problem, so we replaced the gas HW heater about 4 weeks ago... flushed every outlet (faucets/tubs/showers) and things were great. I even removed two bath cartridges to get maximum, right-outta-the-pipe pressure for the flushing. The debris stopped... View more questions Search
|