Not your question?
Ask your question
View similar questions
Add your answer here.Check out some similar questions!
Misuse of ground wire as neutral return wire in old house
[ 5 Answers ]
Here a problem where the "obvious" solution scares me, need some advice on how to best proceed. My home (built 1920 with knob and tube type wiring) has been upgraded over the years by prior owners, but in many place still has active current in the old wires, in other places it is spliced into a...
Connecting 3 wire to a 4 wire service panel
[ 5 Answers ]
I am trying to connect from a 3 wire system at the utility pole to a 4 wire service panel inside a new mobile home. I called an electrician for some advice and was told that I needed to drive an 8ft ground stake and attach a solid copper wire from the stake to the ground bar in the panel. Then I...
Using the ground or (bare) wire for the neutral wire
[ 2 Answers ]
I have a problem with some wiring that I ran for an outside motion light. Although the hot leg and ground wires are fine, the neutral wire is defective ( it may have gotten knicked or something). Of course, now the wiring is covered up behind a wall that I do not want to tear into if it can be...
Neutral wire used as a ground?
[ 3 Answers ]
I have been changing switches and plugs and in one of the receptical boxes I found the neutral wire pigtailed to the side of the box, and when I installed the new receptical there was no circuit until I did the same, pigtailed to the box... is this safe?:confused:
Is it okay to use bare wire as neutral? Okay to share ground?
[ 53 Answers ]
Our house was built in 2003 and it came with a GE 24" microwave oven that uses 120 volts/20 Amp. The microwave stops working so we went out and bought a KitchenAid convection microwave oven that requires 20 Amp, 240 volts, 60 Hertz. The old microwave oven uses 12/2 w/g romex from a subpanel. ... View more questions Search
|