Ask Experts Questions for FREE Help !
Ask
    krazyhoss's Avatar
    krazyhoss Posts: 1, Reputation: 1
    New Member
    		  
    #1

    Feb 27, 2009, 08:17 AM
    Red light continually flashes 4 times
    I have a Nordyne furnace that is trying to ignite. It goes through start cycle but igniter doesn't glow. Makes three attempts then faults, sending fault code "4 blinks of red light.
    What is fault?
    wmproop's Avatar
    wmproop Posts: 3,749, Reputation: 91
    Ultra Member
    		  
    #2

    Feb 27, 2009, 10:10 PM
    The fault codes should be written on the inside of the door panel . Tell what each code means
    Is probably going to say replace igniter
    KidChaos's Avatar
    KidChaos Posts: 45, Reputation: 3
    Junior Member
    		  
    #3

    Jun 30, 2012, 07:58 PM
    Quote Originally Posted by krazyhoss View Post
    I have a Nordyne furnace that is trying to ignite. It goes through start cycle but igniter doesn't glow. Makes three attempts then faults, sending fault code "4 blinks of red light.
    What is fault?
    I agree with previous poster I might add that the ignitor can be visually diagnosed usually, is it cracked or grey anywhere? Or part missing? Ohm iyt out for continuity, and test for 120v after initiating a heast mode and inducer fans on about 30 seconds a click will alert you to test the leads to the ignitor.
Not your question? Ask your question View similar questions
 

Question Tools Search this Question
Search this Question:

Advanced Search

Add your answer here.


Check out some similar questions!

Coleman evron furnace flashes five times [ 4 Answers ]

My coleman furnace will ignite and run for a few minutes and then the flame will go out and will kick on several times.It flashes five times.The furnace says a gas valve energized with no call for heat.What does this mean and how do I fix the problem Thank you

Concord 80 plus gas furnace- Blowing cold air & LED Flashes 4 times [ 4 Answers ]

I am a new home owner and have never dealt with a newer furnace. I woke up and the furnace was blowing out cold air. The LED inside of the furnace flashes four times which says 'Limit or Rollout Switch Open' I honestly have no idea what that means and I really do not have the money for a...

Heater won't kick on LED flashes "2" times ? [ 1 Answers ]

I'm having a problem with my heat kicking on after not using it for the summer , I went to the roof and trouble shooted and there is a LED light that flashes 2 times . The manual says If the Led flashes 2 times it's the end switch , if the end switch doesn't close before the ignition period ....

Hampton Bay Fan/Light: Light flashes intermittently [ 1 Answers ]

Installed fan 3-4 months ago and have had no trouble until past week when light on fan started flashing intermittently. Fan has remote and is wired directly to power source -- no switch. Checked all connections, but cannot figure out why light is flashing. Any help is much appreciated!

View more questions Search