Not your question?
Ask your question
View similar questions
Check out some similar questions!
Best way to cap a copper water line: compression fitting or copper cap?
[ 29 Answers ]
Hi all, Unsuccessfully tried to cap a copper water line by soldering a pre-soldered cap onto the end. Took all the proper steps, cleaned the ends of the pipe and fitting first, then applied flux around both. Wasn't quite sure what I should be heating, so I just heated everything. After my first...
How to conect copper threaded tee to copper piping
[ 14 Answers ]
I tried to install a copper threaded tee which connects 2 ends of copper piping and a line to dishwasher (plastic hose). Still a dripping leak at the joints.
Kettle of fish
[ 27 Answers ]
Hello: "Well, that's a fine kettle of fish you put me in Georgie" Our prospective Attorney General has been put into a tight spot by our fearless leaders (snicker, snicker). He either has to admit that waterboarding is torture (and thereby cause the CIA, the Defense Department, and Georgie...
Sweating copper to copper valve connections
[ 1 Answers ]
I'm replacing my shower with a Moen system that has a Moentrol three function transfer valve Model 3330. The inlet and outlets are copper to copper. Other than removing the cartridges prior to sweating is their any particular trick to heating those connections on the valve? Thanks very much for...
Kettle Temperature
[ 4 Answers ]
Hello, Generally, what temperature does electric kettle water get to? I realise that it's probably slightly different for each kettle, does it ever reach 100 Celsius? Thank You View more questions Search
|