Ask Experts Questions for FREE Help !
Ask
    midlife45's Avatar
    midlife45 Posts: 1, Reputation: 1
    New Member
     
    #1

    Feb 20, 2009, 02:17 PM
    How do I change the idle pulley on a 2001 ford ranger
    How do I change the idle pulley on a 2001 ford ranger
    TxGreaseMonkey's Avatar
    TxGreaseMonkey Posts: 16,761, Reputation: 5597
    Uber Member
     
    #2

    Feb 20, 2009, 05:14 PM

    This link may help:

    https://www.askmehelpdesk.com/cars-t...tml#post637296

    Make a sketch of the serpentine belt layout beforehand, if there's not a decal under the hood.

Not your question? Ask your question View similar questions

 

Question Tools Search this Question
Search this Question:

Advanced Search

Add your answer here.


Check out some similar questions!

Ford Ranger [ 1 Answers ]

2001 Ranger. I found dangling down from left side rear a hose with a cilp. It was attached to the axle housing. What is it for and where does it go. It just appears to be some type of air hose but is not attached to anything at other end. Should I be concerned? Thanks

2001 Ford Ranger [ 4 Answers ]

I recently purchased a 2001 Ford Ranger XLT. The serpentine belt had a bit of an inconsistent 'squeak' sound. I looked at the belt, and found that it is dry-rotted a little and has cracks. I sprayed a product that is supposed to eliminate the squeaking noise (should that be the true problem),...

2001 ford ranger edge v6. Trans fluid [ 1 Answers ]

This truck has 60,500 miles on it and this has the original trans fluid in it. Seems to be working fine. I hear two stories about changing trans fluid. One says you should change the filter too, one says flush only is fine. Which is true?

92 Ford Ranger 2.3L [ 1 Answers ]

Anyone, what problems does the Check Engine light going on usually indicate? I was coming home tonight, about an hour highway drive and the light momentarily came on, then off, on and off. Not a flicker, but for several minutes at a time. Truck is VERy reliable and there is no indication that...

My ford 2.3 in a 91 ranger [ 3 Answers ]

Hey guys my problem is that I just swaped out a 2.3 for another 2.3 and when it runs it idles fine for a little bit then it seems like starts to miss then boggs out and dies and back fires like a cannon so bad it blew a brand new muffler out of round it kind of seems like it gets a rich smell of...


View more questions Search