 |
|
| Browse | Ask | Answer | Search | Join/Login |
|
|
||||
|
Kemore direct drive washer problem
The washer is a Kenmore ultra fabric care. I'll post the model # later if its needed.
This past Sunday the washer stopped agitating, spinning, and draining. Could the timer cause all this at once or am I more likely to find a seized motor? (We just had a flooded basement a few weeks ago) The washer does make a slight buzzing noise when you put it on spin but the motor is definitely not turning. There was a distinct burning smell but to me it seemed to be coming more from top by the timer area than the bottom where the motor is. All help is greatly appreciated. Thanks PopaTim |
||||
Check out some similar questions!
After connecting my external hard drive to a usb port. Assigns to a used drive F. to get to the ext hd I have to disconnect F then I'm able to open the ext hd. How can I get the ext. hd to go to the next available drive letter or can I assign one?
Correct me if I'm wrong... I know when LED on disk drive is lit its reading the disk, but in my case when ever I try to use it, it never off the light unless I turn off my PC or never use my disk drive, oh I mean it for floppy disk drive... I'm afriad to take out the inserted disk cause it may be...
Hi I have a Pentium II,333MHZ and am trying to install a 40GB hard drive. It gets detected as slave no problem but when I set the jumper to master it doesn't get detected as master. On boot up I get a message saying there is no primary master. The system knows it's there and recognizes the full 40...
Sharon, hi, OK, now is the blank CD-RW disk you are using a new blank disk, one that you have never used before? I know this sounds very obvious, but there were many times where I did not label the cd-r or cd-rw disk I just recorded something to, only to accidentally put it back into the drive by...
View more questions Search
| Question Tools | Search this Question |
Add your answer here.
|
