Ask Experts Questions for FREE Help !
Ask
    jsutherlin's Avatar
    jsutherlin Posts: 28, Reputation: 1
    New Member
    		  
    #1

    Feb 8, 2009, 02:50 PM
    Tiling over a tub
    I'm just about ready to install tile over a fiberglass whirlpool tub. I've put up the durock, taped the seams with their fiberglass tape and thinset. One of the durock walls butts up to sheetrock and is a bit lower than the sheetrock. Not thinking ahead, I mudded the gap and smoothed the transition but since the durock was lower than the sheet rock the joint compound is now over the durock. Can thinset/tiles be put over the joint compound (it would be at least 3 vertical rows of tiles)? Can tile adhesive be used instead of thinset in the areas with joint compound?

    Thanks!
    ballengerb1's Avatar
    ballengerb1 Posts: 27,378, Reputation: 2280
    Home Repair & Remodeling Expert
    		  
    #2

    Feb 8, 2009, 07:32 PM

    Tile adhesive is not recommended for wet areas so stick with a modified thinset mortar, not plain thinset. Back to the durock question, by lower do you mean it is not as thick as the drywall, it is inset a bit?
    jsutherlin's Avatar
    jsutherlin Posts: 28, Reputation: 1
    New Member
    		  
    #3

    Feb 9, 2009, 06:53 AM
    Yea, the 1/2" durock isn't quite as thick as the drywall next to it. It looks like they used 5/8" drywall.
    ballengerb1's Avatar
    ballengerb1 Posts: 27,378, Reputation: 2280
    Home Repair & Remodeling Expert
    		  
    #4

    Feb 9, 2009, 08:29 AM

    OK, I better understand your situation. No, I would not try to mount wall tiles over ordinary joint compound which will never be water proof. Scarp, chip out the joint compound and butter that joint just like you did the seams. Modified thinset will be water proof and much stronger resisting cracking. Use this same thinset to mount your tiles.
    jsutherlin's Avatar
    jsutherlin Posts: 28, Reputation: 1
    New Member
    		  
    #5

    Feb 9, 2009, 08:32 AM
    Thanks! Better to re-do it now than have tiles falling off the wall later.
    Bljack's Avatar
    Bljack Posts: 245, Reputation: 28
    Full Member
    		  
    #6

    Feb 10, 2009, 09:41 AM
    Being only one wall, you might consider taking that piece of durock down and furring the wall out to be in plane with the sheetrock. Believe it or not, peel and stick tile make great shims for situations like that. Cut into 1.5" slices and stick them to the stud faces.

    Is this a drop in tub being used as a shower as well? If not, and it's just a soaking tub, it's not considered a wet area and you could get away with what's there now. Though thinset is always better, if there is no shower in most cases mastic will be accetable. If it will also be used as a shower, did it have a tub flange?
    jsutherlin's Avatar
    jsutherlin Posts: 28, Reputation: 1
    New Member
    		  
    #7

    Feb 10, 2009, 01:26 PM
    It is also a shower. I think it's too late to take off the durock and raise it up, it's been taped on all other sides and its attached to the wall with a billion screws. :-) I think I will scrape off the joint compound and build it up slightly with modified thinset... fun. Thanks!
    ballengerb1's Avatar
    ballengerb1 Posts: 27,378, Reputation: 2280
    Home Repair & Remodeling Expert
    		  
    #8

    Feb 10, 2009, 01:28 PM

    I think you will be OK. How large are your tiles and what size towel were you planning to use? A 1/4" notched trowel will raise your tiles bottom surface over 1/8".
    jsutherlin's Avatar
    jsutherlin Posts: 28, Reputation: 1
    New Member
    		  
    #9

    Feb 11, 2009, 06:36 AM
    The tiles are 6x6. I was going to use a smaller trowel but using the 1/4" sounds like it would be perfect! Thanks.
Not your question? Ask your question View similar questions
 

Question Tools Search this Question
Search this Question:

Advanced Search

Add your answer here.


Check out some similar questions!

Tiling next to a tub [ 4 Answers ]

My buddy is doing some work on his bathroom and he's running into a jam with his tub. When his 1-piece tub was installed 20 years ago, the floor was tiled underneath the tub and there is a gap between the floor and the base of the tub. The owners put one of those cheap rubber adhesive strips down...

Tiling around jetted tub [ 1 Answers ]

I have recently re-done the walls in my masterbath. I have a jetted tub that had carpet around it. I removed the carpet and found a plywood base. I would like to install floor heat and tile the floor, as well as tile the surround around the tub and part of the walls. Do I need to put cement...

Tiling in Kitchen [ 3 Answers ]

Just wondering about tiling a new black splash in an older kitchen do I need to remove the drywall and install wonderboard onto the studs? Or can I go over top of drywall with wonderboard? Or just tile directly onto the drywall? Want to use 1/4 inch wonderboard if going over top and if I have to...

Tiling [ 1 Answers ]

I am remodeling my first bathroom. I am planing on tiling the shower/tub.. my question is the transition from tile to painted wall.. with the cement backer do I butt it up to drywall? What do I do about the seam? Mud and tape?

Tiling question [ 1 Answers ]

I am remodeling my first bathroom. I am planing on tiling the shower/tub.. my question is the transition from tile to painted wall.. with the cement backer do I butt it up to drywall? What do I do about the seam? I plan on tiling to the ceiling to avoid this problem there, but what about the sides?...

View more questions Search