Ask Experts Questions for FREE Help !
Ask
    pusdlb's Avatar
    pusdlb Posts: 4, Reputation: 1
    New Member
    		  
    #1

    Jan 25, 2009, 03:16 PM
    Honeywell Prog T-Stat #RLV430A Wiring
    I want to change out my old HW round manual T-stat for RLV430A. There are 4 wire coming out of the wall -red,yellow,white,yellow. The new one only has 2 black wires - I cannot figure out how to combine these. The unit is propane forced air. The directions for new one does not address my problem. Any advice?? Thanks
    Missouri Bound's Avatar
    Missouri Bound Posts: 1,532, Reputation: 94
    Ultra Member
    		  
    #2

    Jan 25, 2009, 06:21 PM
    Youneed to go back to the furnace and see what wires are connected to the gas valve. You have heat only available... right?
    pusdlb's Avatar
    pusdlb Posts: 4, Reputation: 1
    New Member
    		  
    #3

    Jan 26, 2009, 04:00 PM
    It's Heating and Air - the duct work is there - it's like a natural gas pack only we live where there are no gas lines in area, so we have a buried tank for propane!
    Thanks - Lee
    Missouri Bound's Avatar
    Missouri Bound Posts: 1,532, Reputation: 94
    Ultra Member
    		  
    #4

    Jan 26, 2009, 06:06 PM
    Usually wires are color coded upon installation to make this a no-brainer. Since it wasn't done you need to find out where each wire goes before you can wire the new thermostat. Can't help you any further unless you pull all new wires.
    easy12589's Avatar
    easy12589 Posts: 1, Reputation: 1
    New Member
    		  
    #5

    Sep 19, 2009, 03:01 PM
    Model # RLV430A thermostat is for an electric base board heater
Not your question? Ask your question View similar questions
 

Question Tools Search this Question
Search this Question:

Advanced Search

Add your answer here.


Check out some similar questions!

Wiring in a new honeywell t4360 frost stat [ 3 Answers ]

Can anyone tell me how to wire up this new frost stat

Wiring a rth7400 honeywell Heatpump t-stat [ 2 Answers ]

I am at my witts end with trying to wire this T-stat I am removing an old honeywell heatpump M# T874D1165 and replacing it with an RTH7400 programmable I have 7 wires running out of wall, here's what I have, BROWN and WHITE hooked to W-2 (with jumper going to Y-2) YELLOW going to...

Trane Heat Pump tstat replacement with Honeywell prog - wiring question [ 1 Answers ]

I want to replace my Trane Weathertron tstat with a Honeywell RTH7400 prog one. I have a Trane heat pump with aux heat. I've been poring over these thread piece-mealing some info the follow is the result. The old wiring scheme: X2 - black O - orange G - green Y - yellow T - tan/brown R -...

Amana vs honeywell stat wiring [ 5 Answers ]

My system consists of a heatpump(amana ) / air /gas furnace. I'm presently using an amana stat (T874tg189910574101 ) and plan on changing to a Honeywell 7400 5-1-1. The amana stat uses terminals: e jumpered to w2 with tan wire , g , c / x , r , y , and o. The honeywell diagram only shows 5 wires...

View more questions Search