Not your question?
Ask your question
View similar questions
Add your answer here.Check out some similar questions!
Grounding / Water Pump / DSL service
[ 11 Answers ]
Looks like a great community I've discovered here. Hopefully someone can help me out. I will try and keep it short - By accident, I have discovered that my well system is intefering with my DSL service. Turn on the water, and SNR as reported by the DSL modem drops from 15-16 to 5-6. As you...
Water hammering, water arresters, big pipe flowing into small pipe
[ 2 Answers ]
Hi, I have a water hammer (I'm guessing) problem in our house. All the pipes are under the house and it is a timber house so each time there is a water hammer noise it is extremely noisy. Basically any tap in the house is making the noise when turning on or off quickly with loud bangs. Cold...
Grounding a water heater element
[ 3 Answers ]
I am trying to use a stainless steel sanke beer keg as a cooker for my brewing and want to convert it to an eletrical heat source. I purchased a water heater element and a 220V rated sealed dryer cord with plug. I know that the two hots get connected directly to the element, but what do I do...
Teflon or Pipe Dope for 1 1/4" Water Pipe
[ 7 Answers ]
I am building a project that uses several joints of 1 1/4 " galvanized pipe, including elbows and Tee's. The unit will be plumbed into my 50 psi water system. What is the best way to seal the pipe joints? I have assembled the unit and tested using teflon pipe dope and had several leaks.
Grounding a boost water pump
[ 3 Answers ]
Hi all, I would like some advice on grounding a water boost pump. It is 750 ft down the hill from the house and a conduit is installed to supply power to it. It is 220 volt single phase 1/2 horse 6.5 amps. Is grounding accomplished by an EGC from the main panel or can the pump be grounded only by... View more questions Search
|