Not your question?
Ask your question
View similar questions
Add your answer here.Check out some similar questions!
Can Nashua 324 Tape be use on the INSIDE of metal duct at furnace out take?
[ 9 Answers ]
I've used nashua 324A tape to seal up the custom metal duct I had to create to connect up my furnace to the existing heating duct. I used it on the inside and outside and was wondering if I'm at risk of a possible fire. The tape is rated to 325 degrees but I just wanted get some confirmation...
Wiring "in duct" fans to main blower circuit ?
[ 6 Answers ]
HI, I have a self contained heating/air unit mounted outside the house. Everything runs fine but was getting hot and cold spots inside. Mounted two in duct fans to"push" the air to all registers evenly. I want to wire it to the unit blower so they all come on at the same time. At the unit...
Residue from duct tape on ceramic tile
[ 3 Answers ]
We used some duct tape to hold the tiles in place on a vertical surface, now we need to clean the residue without scratching the glazed surface. I tried using acetone nail polish remover, but it dries too rapidly. Any suggestions?
How much pipe thread tape to use?
[ 5 Answers ]
Yikes. I was installing the tub spout and the copper stub-out was way too long. I measure and measured again and cut it too short. It doesn't extend far enough Into the spout to seal. Can I use silicone or something? What others options To I have? The spout is the type you described in a...
Main pipe backup
[ 3 Answers ]
Hi, I am new and I have a question about a backup in my main drain. I am don't know plumber lingo so bear with me. The problem is I bought this house in 2003, the first year there was a backup when we would run the washer.we called a plumber and he snaked it out and found roots, he told us that it... View more questions Search
|