Ask Experts Questions for FREE Help !
Ask
    EdVan's Avatar
    EdVan Posts: 1, Reputation: 1
    New Member
     
    #1

    Jan 10, 2009, 04:57 AM
    Trane xv80 fan runs in on but not auto
    Trane xv80 starts and runs fine... there is nice blue flame, everything is blowing, then the main blower quits, flame keeps going until safety device shuts it off. This is all with fan in auto or on position

    Without call for heat, fan runs all day in on position, and does not run in auto position.

    What could be causing this?
    KC13's Avatar
    KC13 Posts: 2,556, Reputation: 99
    Ultra Member
     
    #2

    Jan 10, 2009, 09:15 AM
    Probably a bad circuit board. Check for evidence of burned circuit paths or relays. You may be able to wire in the blower hot for interim heating.
    hvac1000's Avatar
    hvac1000 Posts: 14,540, Reputation: 435
    Heating & Air Conditioning Expert
     
    #3

    Jan 10, 2009, 09:41 AM
    Could also be a defective motor. You might try to feel the motor with the power off to see if it is over heating.

Not your question? Ask your question View similar questions

 

Question Tools Search this Question
Search this Question:

Advanced Search

Add your answer here.


Check out some similar questions!

Trane xv80 not staying lit [ 4 Answers ]

My furnace is 5 years. Every time it calls for heat it fires up just fine but then after 3 sec. the gas turns off, it repeats this cycle until it locks out the system. I have reset the system, checked all the wiring for loose connections but cannot get it to run. Please help me.

Trane XV80 and Honeywell RTH7500D [ 1 Answers ]

Having some problems. Background: Trane XV80 and Honeywell RTH7500D I have 5 wires coming from the controller board on the gas furnace: W1 (white) R (red) G (green) Y (yellow) and

HVAC Trane xv80 blower motor [ 2 Answers ]

Trane XV80 Installed 2002 My blower does not come on; I turned t-stat to fan only; fan motor felt cold to touch and turns freely when spyn: defeateded the safety switch on front; checked voltage at the leads from the circuit board to fan motor for the white and black leads(124 v); Should I...

Trane XV80 blower not running [ 2 Answers ]

:( I have a Trane XV80 blower motor will not run, it will spin freely, the control board has normal slow blink, but GS3 yellow LED light above green wire is on, when A/C turned on the condensing unit runs but no blower, Heat on no blower but get trouble light high limit lockout, and just turn...

Trane xv80 [ 1 Answers ]

Main blower mysteriously stopped working on Trand XV80. I've gone through the owner's manual. No fix. Vent blower works, flames present, no main blower. 16 Months old. Any suggestions?


View more questions Search