Ask Experts Questions for FREE Help !
Ask
    scottc2u's Avatar
    scottc2u Posts: 1, Reputation: 1
    New Member
    		  
    #1

    Dec 15, 2008, 08:47 AM
    AC/Furnace Plug in closet has No Power
    I have fliiped the breaker, and I still get no power to the plug inside the AC/Furnace closet. I have run a small extension cord to the nearest plug so we have heat for now. I changed the plug inside the closet to a new one from home depot, but I still have no power. Don't know what to do from here, any help would be appreaciated.
    hvac1000's Avatar
    hvac1000 Posts: 14,540, Reputation: 435
    Heating & Air Conditioning Expert
    		  
    #2

    Dec 15, 2008, 01:00 PM
    Check the electric circuit from the house electric panel to the plug. Make sure the breaker is turned on so the voltage will be on to the plug so the unit will run. If that fails call an electrician. Extension cords are BAD news.
Not your question? Ask your question View similar questions
 

Question Tools Search this Question
Search this Question:

Advanced Search

Add your answer here.


Check out some similar questions!

12-3 wiring from gfi plug to outlet to plug in a 110v pool pump [ 5 Answers ]

Need to verify proper wiring for above 110v pool pump.

R&R furnace to HE in Closet, can I seal vent holes? [ 1 Answers ]

Removed old down-draft gas furnace in closet area and replaced with High Efficiency down-draft. Combustion air vented from outside as well as exhaust. Not a typical straight up through roof or chimney, but through a exterior wall. All the necessary ends for both feeds are in place. The question...

Lead closet replaced by pvc closet on toilet [ 4 Answers ]

Plumber replaced a lead closet with a pvc closet and now the toilet doesn't line up the way it used to.. It is forward 2" and sideways about 1-1/2 " Plumber says that is the best he can do.. I don't believe that . Is there a way it can line up like before.

Low power in plug when light is on [ 1 Answers ]

I have 2 recepticals in a bedroom on the same circuit as the light in the bath. When I turn on the light in the bath the power in the receptical seems like its draing down to zero and the ight in the bath dims low. Its like something darins the curren. Any idea?

Romax type wire to plug conversion on furnace [ 10 Answers ]

Hello – about ten years ago I had a new gas hot water heater and gas furnace installed in my home. (Converted from electric heat & water talk about savings) The installers picked up the electric from a standard basement porcelain single bulb fixture (about 5 feet from the new equipment). The hot...

View more questions Search