Ask Experts Questions for FREE Help !
Ask
    lilsis7's Avatar
    lilsis7 Posts: 1, Reputation: 1
    New Member
    		  
    #1

    Dec 11, 2008, 05:18 AM
    Gas Furnace Fan
    Replaced fan on G20re furnace late summer.Thermostat was clicking on and off, replaced thermostat, now fan is only kicking on intermittently. Have hit the unit couple if times and it will kick on. Loose wire?
    hvac1000's Avatar
    hvac1000 Posts: 14,540, Reputation: 435
    Heating & Air Conditioning Expert
    		  
    #2

    Dec 11, 2008, 06:14 AM
    Loos wire it could be. Also a defective fan control or relay.
    dac122's Avatar
    dac122 Posts: 463, Reputation: 17
    Full Member
    		  
    #3

    Dec 11, 2008, 10:46 AM


    Dope-slaps only work on people, not HVAC equipment. :)

    What are you hitting: the tstat or air handler?
    MarkwithaK's Avatar
    MarkwithaK Posts: 955, Reputation: 107
    Senior Member
    		  
    #4

    Dec 11, 2008, 05:02 PM
    Quote Originally Posted by dac122 View Post
    Dope-slaps only work on people, not HVAC equipment. :)
    If only that were true :p.

    Can't even begin to count how many low pressure controls or fan cycle switches I have had to influence with a little whap from my linemans.
Not your question? Ask your question View similar questions
 

Question Tools Search this Question
Search this Question:

Advanced Search

Add your answer here.


Check out some similar questions!

York Stellar Furnace Heating up Furnace Room to 110 Degress? [ 2 Answers ]

I have a York Stellar Furnace in my newly purchased house. Furnace is 15 years old. Furnace is releasing hot air from front grills and heats up furnace room to 110 Degrees. I had a Bryant Furnace in another house and this never happened. All plenams and ducts are taped and sealed so the heat is...

Goodman furnace GMNT080-4 furnace runs good for a while then has to be manually reset [ 5 Answers ]

I have a Goodman GMNT080-4 (90%). I'm having the same problem As Streatherg did back in the Nov 2006 question. I reviewed his article and tried Every thing on there but seems to be doing the same thing. The furnace kicks on for about an hour then locks out and has to be manually reset threw...

My intertherm furnace pilot lights but furnace won't kick on [ 5 Answers ]

I need some diagnostic help. We have a full propane tank. A new burner plate (last year) and the blower works. We light the pilot but the knob should pop up after one minute thus lighting the furnace. It won't pop up. What part should we replace? The furnace is a 17 year old Intertherm MGH...

Furnace not heating the house. Damper on the furnace not opening. Motor then shuts. [ 4 Answers ]

My forced-air furnace is not working correctly. The gas works heating the air in the furnace, but When the motor starts the damper doesn't open and the Motor shut down. I need suggestions?:mad:

Comfortmaker Furnace Fan blows in line fuse and will not allow furnace to work [ 1 Answers ]

I have a Comfortmaker Furnace (approximately 1998/99) and the fan will not turn on allow the furnace to heat. When I try to turn the furnace on it blows a 3 amp fuse at the blower motor. I removed the fuse and jumped it and all it will do is make a faint buzzing noise and not turn on. I can...

View more questions Search